Anonymous posted a question about 1985 Ford F150:
"I have an 85 f150 with a 351 windsor h/o with 4 barrel carb. It starts and runs great. It..."
Anonymous posted an answer for this 2000 Mitsubishi Eclipse:
"There is a panel inside the wheel well that you can take off that gives you perfect access..."
Anonymous posted an answer for this 2000 Mitsubishi Eclipse:
"pull back the carpet in the trunk around the taillight assembly. i think there are 4 bolts..."
Anonymous posted an answer for this 2001 Nissan Altima:
"You have to go to the dealer to get a coded key made for the car. Its expensive."
Anonymous posted an answer for this Hyundai Motor 2002 Elantra:
"The lug bolts are all you need to take off. the big bolt in the middle holds the spindle..."
Anonymous posted an answer for this 1997 Dodge Caravan:
"Ok. that makes more sense. the relay should be in the fuse box under the hood. it should..."
Anonymous posted an answer for this 1999 Oldsmobile Bravada:
"Camber adjustment is part of the alignment. who told you that?"
Anonymous posted an answer for this 1999 Nissan Maxima:
"check the battery"
Anonymous posted an answer for this 1997 Dodge Caravan:
"some cars fans are meant to run for a min or so after you shut it off. my saab does that...."
Anonymous posted an answer for this 2000 Alfa Romeo 145:
"The timing belt is synchronous and will not slip. if it did your car wouldn't run. it is..."
Anonymous posted an answer for this 2007 Yamaha YZF-R6:
"that seems to be a common problem. its a valve in the exhaust thats supposed to make the..."
Anonymous posted an answer for this 2002 Suzuki GSX-R 600:
"there are 3 things you need for the bike to start. fuel, air, and fire. you checked the..."
Anonymous posted an answer for this 2001 Chevrolet Tracker:
"yes. replace rotors and pads and you will be ready to roll."
Anonymous posted an answer for this 1994 Honda Civic:
"thats probably the timing belt/chain depending on what your car has. when it gets hot its..."
Anonymous posted an answer for this Honda Cars & Trucks:
"the abs is supposed to work all the time. the chattering you are talking about is probably..."
Anonymous posted an answer for this 2002 Jeep Grand Cherokee:
"Just adjust the idle down."
Anonymous posted an answer for this Dodge Cars & Trucks:
"i don't have a diagram but the ball joints are directly under the hub. they are what..."
Anonymous posted an answer for this 1991 Jaguar XJ6:
"I always use a c-clamp to push the piston in with. you won't be able to replace the pads..."
Anonymous posted an answer for this 1996 Ford Thunderbird LX:
"Umm.. subs are usually meant for bass. do you mean amp power wire? if you just want to be..."
Anonymous posted an answer for this 1997 Jeep Grand Cherokee:
"Check the fuses and relays first. if they are good, try replacing the bulbs."
Anonymous posted an answer for this 1992 Mitsubishi Mirage:
"replacing distributor cap, rotor button, plugs, and wires should do the trick."
Anonymous posted an answer for this 2002 Dodge Stratus:
"you need to replace switch."
Anonymous posted an answer for this Ford Cars & Trucks:
"there should be a main fuse in-line from the battery. try checking that. if that is good,..."
Anonymous posted an answer for this 1998 Volvo S70:
"check the fluid level in the transmission"
Anonymous posted an answer for this Hyundai Motor 2004 Sonata:
"the marks are usually on the pulleys where the timing belt goes."
Anonymous posted an answer for this 1999 Dodge Caravan:
"could be one or more of a couple hundred things. take it to an auto parts store like napa..."
Anonymous posted an answer for this 2003 GMC Sonoma Extended Cab:
"I would trying changing the fluid in it before you go through all that. I would probably..."
Anonymous posted an answer for this 1988 Toyota Land Cruiser:
"I'm guessing you mean 200k? Quaker state high mileage is good."
Anonymous posted an answer for this 1992 Chevrolet Astro Extended:
"Same thing happened to my car. Its a bad sensor. i never replaced it but i would assume it..."
Anonymous posted an answer for this 2000 Plymouth Neon:
"its a pain. not really any room to work and if you get one of the pulleys off by one tooth..."
Anonymous posted an answer for this 1991 Mazda MPV:
"you can get one at a salvage yard pretty cheap. since your not mechanically inclined i..."