1If I know, I'll tell you.
Anonymous posted an answer for this Televison & Video:
"Make sure the speakers aren't turned off. It will be in the menu section under audio or..."
AnonymousAnonymous posted an answer for this Televison & Video:
"If it's bright green with light lines from side to side the green gun is shorting out. You..."
Anonymous
Anonymous posted an answer for this 1992 Honda Accord:
"The fuel pump relay is the most likely cause of your problem. On most Civic's it is under..."
Anonymous
Anonymous posted an answer for this Philips 42FD9932 42 in. Plasma Television:
"If the back was off the board on the left is your Ysus board. It will have a cable plugged..."
AnonymousAnonymous posted an answer for this Televison & Video:
"Change the STK 392 IC's on their heat sinks. Check for bad resistors in the area. Check..."
Anonymous
Anonymous posted an answer for this Philips Magnavox 27MS343S 27" TV:
"Try putting in a VCR tape let it load and hit stop. If the set stays on it's the VCR deck..."
AnonymousAnonymous posted an answer for this Televison & Video:
"There are two identical IC's I think they are 18 pin more or less about half way up the..."
AnonymousAnonymous posted an answer for this Televison & Video:
"The STK's are probably blown again. You need to pay close attention to the resistors..."
Anonymous
Anonymous posted an answer for this GE 25GT240 25" TV:
"The Flyback transformer is arcing. You could change it or if available replace the whole..."
AnonymousAnonymous posted an answer for this GE 25GT240 25" TV:
"The Flyback Transformer is probably shorted to the core and shorted out the Horizontal..."
Anonymous
Anonymous posted an answer for this LG 32LX1D 32 in. LCD Television:
"At the top of the Signal module there may be a surface mounted resistor marked 100. It's..."
AnonymousAnonymous posted an answer for this LG 32LX1D 32 in. LCD Television:
"You could try removing the ribbon cable directly under where the lines are from the X..."
AnonymousAnonymous posted an answer for this LG 32LX1D 32 in. LCD Television:
"It is most likely the power supply. If you see domed caps change them using a higher..."
AnonymousAnonymous posted an answer for this LG 32LX1D 32 in. LCD Television:
"Change the Capactors in the power supply yourself. Most of the time the tops of the bad..."
AnonymousAnonymous posted an answer for this LG 32LX1D 32 in. LCD Television:
"Bad caps in the power supply. Replace all bad cap or replace Power Supply Module. If you..."
Anonymous
Anonymous posted an answer for this Philips 42PF9630A 42 in. Plasma Television:
"The Z sustain module blew it's transistors. It may have been initiated by the Y sustain..."
AnonymousAnonymous posted an answer for this Philips 42PF9630A 42 in. Plasma Television:
"The capacitors in the power supply are probably bad. The best way to check them in circuit..."
AnonymousAnonymous posted an answer for this Televison & Video:
"Probably a bad picture tube but I would need more information like Brand and Type."
AnonymousAnonymous posted an answer for this Televison & Video:
"If it is a older Zenith Big Screen and not a DLP ,LCD or Plasma, it would most likely be..."
AnonymousAnonymous posted an answer for this Televison & Video:
"What Brand and Model do you have ? It sounds like your set is in shutdown and is blinking..."
AnonymousAnonymous posted an answer for this RCA P61930BL 61" Rear Projection Television:
"NO !! You can't adjust that out. You have a convergence failure. You need to take it to a..."
Anonymous
Anonymous posted an answer for this Daewoo DP42SM 42 in. HD-Ready Plasma Television:
"It could be the panel but it could also be the ribbon cable that attaches to the display..."
Anonymous
Anonymous posted an answer for this RCA HD50LPW42 50" Rear Projection HDTV:
"Thats a DLP and those fans are noisy. Most of those fans are special and I don't think I..."
AnonymousAnonymous posted an answer for this Televison & Video:
"If the tuner is not damaged many shops will replace it for you for $50. If you want to try..."
AnonymousAnonymous posted an answer for this Televison & Video:
"The microswitchs are probably leaky. Ask your local TV shop what they would charge to..."
Anonymous
Anonymous posted an answer for this RCA P61960 61" Rear Projection Television:
"Check all three CRT modules for cracks. It would be between the CRT pins and the connector..."
AnonymousAnonymous posted an answer for this RCA P61960 61" Rear Projection Television:
"That sounds like a Pincushion problem if you having bowing. It's probably bad caps and..."
AnonymousAnonymous posted an answer for this RCA P61960 61" Rear Projection Television:
"Contact TV shops around your area. Most shops will sell you a good used one for a hundred..."
AnonymousAnonymous posted an answer for this RCA P61960 61" Rear Projection Television:
"It will depend on the Chassis number you have but it sounds like a bad Deflection module..."
AnonymousAnonymous posted an answer for this RCA P61960 61" Rear Projection Television:
"The Micro switches are leaky. They are soldered on the control panel in the front. Either..."
Anonymous
Televison & Video 29 answers
Cars & Trucks 1 answer
