3With access to plenty of resources
Steve Hurc posted an answer for this Isuzu Cars & Trucks:
"The engine ECU for a 4JJ1 engine is on inside of RHF guard"
Steve HurcSteve Hurc posted an answer for this Isuzu Cars & Trucks:
"What country is the truck from & what is the VIN number & what system do you need...."
Steve HurcSteve Hurc posted an answer for this Isuzu Cars & Trucks:
"no 2 different in years & engine"
Steve HurcSteve Hurc posted an answer for this Isuzu Cars & Trucks:
"yes auto or manual vehicles must have the flex plate (Auto), flywheel (Man) installed in..."
Steve HurcSteve Hurc posted an answer for this Isuzu Cars & Trucks:
"put key in ignition and turn to on position, engine not running, with door open. Then..."
Steve HurcSteve Hurc posted an answer for this Isuzu Cars & Trucks:
"the radio has a fault. This is now an obsolete radio that cannot be repaired. You can..."
Steve Hurc
Steve Hurc posted an answer for this 2004 Isuzu Rodeo:
"so this engine should be an 6VE1, this has got shims on top of the valves. So best to go..."
Steve HurcSteve Hurc posted an answer for this Isuzu Cars & Trucks:
"you should be fine with the standard genuine Isuzu tow bar. The rear of the vehicle may be..."
Steve HurcSteve Hurc posted an answer for this Isuzu Cars & Trucks:
"main head bolts - 1st step-70NM, 2nd step-70NM, 3rd step-60-75 degrees turn angle, 4th..."
Steve HurcSteve Hurc posted an answer for this Isuzu Cars & Trucks:
"ring Steve at North East Isuzu, he is technical support and can E-mail section of workshop..."
Steve HurcSteve Hurc posted an answer for this Holden Cars & Trucks:
"are you still needing the workshop manual? if so I can help."
Steve HurcSteve Hurc posted an answer for this Isuzu Cars & Trucks:
"square box on top of intake manifold"
Steve HurcSteve Hurc posted an answer for this Isuzu Cars & Trucks:
"Neutral switch signal not changing on manual models check Neutral switch on gear box for..."
Steve Hurc
Steve Hurc posted an answer for this 1998 Holden VT Commodore:
"no the code is not 1013 it should flash this same sequence 3 times (one flash small pause..."
Steve HurcSteve Hurc posted an answer for this Holden Cars & Trucks:
"If door is in jammed state, open door by repeatedly pressing the unlock button, while..."
Steve HurcSteve Hurc posted an answer for this Cars & Trucks:
"have seen mechanical issue inside steering box (balls that run on worm drive of input..."
Steve HurcSteve Hurc posted an answer for this Isuzu Cars & Trucks:
"head bolts98 N?m (10 kg?m/72 lb?ft) ?147 N?m (15 kg?m/108 lb?ft) ? 30° - 60° big..."
Steve HurcSteve Hurc posted an answer for this Isuzu Cars & Trucks:
"if flywheel is fitted in correct position the timing mark on the front top cambelt gear is..."
Steve HurcSteve Hurc posted an answer for this 2004 Isuzu Rodeo:
"Valve Clearance Standard Value (cold) Intake: 0.23 mm 0.33 mm (0.0091 in 0.0130 in)..."
Steve Hurc
Steve Hurc posted an answer for this 2004 Holden Astra:
"remove inside black plastic triangle pieces under carpet or service flap light assembly..."
Steve HurcSteve Hurc posted an answer for this 1998 Holden VT Commodore:
"each tower should read about 6kilo ohms when measuring with multi meter from top to top of..."
Steve HurcSteve Hurc posted an answer for this Holden Cars & Trucks:
"the rear pistons in the caliper have to be wound in while pushing on piston to reset worm..."
Steve HurcSteve Hurc posted an answer for this Holden Cars & Trucks:
"it could have engine dammage or just that the exhaust is full of engine oil from old turbo..."
Steve HurcSteve Hurc posted an answer for this Holden Cars & Trucks:
"no this wont make any difference"
Steve HurcSteve Hurc posted an answer for this Holden Cars & Trucks:
"where the pipe from the intercooler goes onto inlet manifold rear left side"
Steve HurcSteve Hurc posted an answer for this Holden Cars & Trucks:
"known issue take to holden dealer so they can update the software in the bcm 10-CS-01..."
Steve Hurc
Steve Hurc posted an answer for this 2006 Holden Barina:
"are they using genuine pads? have had aftermarket pads cause this"
Steve HurcSteve Hurc posted an answer for this Holden Cars & Trucks:
"these had issues of not starting when cold and missfiring only when cold this was due to..."
Steve Hurc
Steve Hurc posted an answer for this 1999 Holden VT:
"take it to an lpg repairer due to laws and regulations"
Steve Hurc
Cars & Trucks 452 answers
Computers & Internet 4 answers
Vehicle Parts &... 1 answer
Air Tools & Compressors 1 answer
Car Audio & Video 1 answer
