DavidWestYorks posted an answer for this Bosch Washing Machines:
"Check that the load is within the 6kg limit and not entangled into a ball, which will..."
DavidWestYorks posted an answer for this Bosch Washing Machines:
"Original advice in 2014 from Kenjo, on another website: f21 is worn brushes in the motor..."
DavidWestYorks posted an answer for this Bosch Washing Machines:
"Probably a blocked or faulty internal inlet valve; check the feed filter which is visible..."
DavidWestYorks posted an answer for this Washing Machines:
"Check your user instructions, if you have them. If not, download a copy from the maker's..."
DavidWestYorks posted an answer for this Kenmore Washing Machines:
"Probably a worn-out bearing; try rocking the empty drum by hand within the tub. If it is..."
DavidWestYorks posted an answer for this Bosch Washing Machines:
"Try ManualsLib.com if you cannot find one from the Bosch Customer assistance site."
DavidWestYorks posted an answer for this Samsung Washing Machines:
"DW7933 is a dishwasher? (This question was found in the washing machine enquiries.) If you..."
DavidWestYorks posted an answer for this Electrolux Washing Machines:
"Loud buzz is likely to be from the motor, due to a failed start / run capacitor. mention..."
DavidWestYorks posted an answer for this Washing Machines:
"Please state model number, and age of machine."
DavidWestYorks posted an answer for this Washing Machines:
"WARNING: DO NOT ATTEMPT TO DISMANTLE YOUR MACHINE UNLESS YOU ARE COMPETENT TO DO..."
DavidWestYorks posted an answer for this Frigidaire Washing Machines:
"It could be a mechanical problem. Check that the door seal is not swollen or bulged. Is..."
DavidWestYorks posted an answer for this Kitchen Appliances - Others:
"Normal fryers operate in the range 350-375?F. Safety cut-outs (also called "limit" or..."
DavidWestYorks posted an answer for this Maytag Neptune MAH5500B Front Load Washer:
"Could be damaged door seal or possibly faulty door hinge."
DavidWestYorks posted an answer for this Whirlpool WFW8300SW:
"Faulty logic board - or faulty Start button."
DavidWestYorks posted an answer for this Kenmore 24032\24036 Top Load Washer:
"If the lid switch is faulty, or incorrectly adjusted, the drive motor is prevented from..."
DavidWestYorks posted an answer for this Whirlpool Washing Machines:
"Possibly a piece of grit or similar has got trapped in the valve, preventing it from..."
DavidWestYorks posted an answer for this Heating & Cooling:
"This may be a flue problem; stop using the appliance until it has been examined by an..."
DavidWestYorks posted an answer for this Honda Cars & Trucks:
"First advice: do not park the car in the garage until you've found the cause of the smell..."
DavidWestYorks posted an answer for this Washing Machines:
"Take a look at the user instructions. In some cases, there's a bar or lever you have to..."
DavidWestYorks posted an answer for this Zanussi F1045W Front Load Washer:
"Could be that the drive pulley behind the drum has loosened on the shaft. You do not say..."
DavidWestYorks posted an answer for this Hoover UltraCare HC6 145M Front Load Washer:
"The cold water feed pipe is attached to the inlet solenoid valve. That's a nylon-looking..."
DavidWestYorks posted an answer for this Washing Machines:
"Could be a faulty latch switch. Also if the latch spring is weakened, the switch won't..."
DavidWestYorks posted an answer for this Washing Machines:
"Don't use eucalyptus oil, because it will damage the rubber, and the smell will..."
DavidWestYorks posted an answer for this Washing Machines:
"Depends what cycle it's used on. For example "Spin" uses no water at all. If you want to..."
DavidWestYorks posted an answer for this Washing Machines:
"What type of machine is it? (Make, model number?). If you have no user instructions, you..."
DavidWestYorks posted an answer for this AEG L74800 Front Load Washer:
"See page 23 of the (UK) user's instructions, which you can download from the AEG website...."
DavidWestYorks posted an answer for this GE WSM2700W Unitized Spacemaker Washer and Dryer:
"The motor is overheating, so the internal thermal protector cuts out. Did you check the..."
DavidWestYorks posted an answer for this Maytag Washing Machines:
"That's not a good idea. The lid lock is there for safety."
DavidWestYorks posted an answer for this Miele Touchtronic W1213 Front Load Washer:
"Foam has probably got into the logic board, and a new board is probably needed. Sorry !"
DavidWestYorks posted an answer for this Washing Machines:
"Could be failure of the drive spider. Do not use the machine until you've had it checked...."
DavidWestYorks posted an answer for this 1992 Mitsubishi 3000GT:
"I'm not familiar with this model, but have you checked that the fuel tank breather is..."