If I'm not sure of an answer I'll let you know.
Rick Gillis posted an answer for this 2003 Chevrolet Silverado 1500:
"Your blower resistor has failed. It will only give you high speed when it has. It's either..."
Rick Gillis posted an answer for this 2000 GMC Jimmy:
"The cluster will be setup for your vehicle I work at a GM dealer and to replace a cluster..."
Rick Gillis posted an answer for this 1999 Dodge Ram 2500 4WD:
"new: www.rockauto.com used: www.car-parts.com"
Rick Gillis posted an answer for this 2007 Chevrolet Uplander LS Minivan:
"Need to get ABS looked at as ABS controls TRAC"
Rick Gillis posted an answer for this 1993 Chevrolet Cavalier:
"Depending on the condition of the line you could splice in a replacement line. You will..."
Rick Gillis posted an answer for this 1998 Chevrolet C1500:
"It is possible but i do reccomend changing the bearing races in the hub when you do it to..."
Rick Gillis posted an answer for this 2003 Chevrolet Silverado 2500HD:
"DTC P1093 Fuel Rail Pressure Low During Power Enrichment The engine control module..."
Rick Gillis posted an answer for this 2007 Ford F-150 Harley Davidson:
"It most likely has water in it but not enough to turn the light on constantly"
Rick Gillis posted an answer for this 2007 Dodge Ram 3500 Quad Cab Laramie:
"Can you hear the turbo spooling up? If yes do you hear an air noise... could a number of..."
Rick Gillis posted an answer for this 2001 Dodge Ram 2500 Truck:
"The check valve on the fuel line at the filter housing may be leaking back not maintaining..."
Rick Gillis posted an answer for this 2001 Dodge Ram 2500 Truck:
"The turbo works off the heat of the exhaust gasses it will be slow to spool up if the..."
Rick Gillis posted an answer for this 2001 Dodge Ram 2500 Truck:
"Pull the fuel filter and FILL it with clean fuel and try turning it over."
Rick Gillis posted an answer for this 2004 GMC Envoy:
"The A/C compressor clutch may be bad"
Rick Gillis posted an answer for this 1998 Honda Passport:
"Check for low fluid levels"
Rick Gillis posted an answer for this 2004 Chevrolet Blazer:
"I'd recommend a brake inspection you may have a glazed rotor."
Rick Gillis posted an answer for this 2002 GMC Sierra:
"It may be a rear crank seal, or oil from the torque converter (automatic) or the input..."
Rick Gillis posted an answer for this 2001 Chevrolet Silverado 1500:
"Blower Motor Resistor Replacement Removal..."
Rick Gillis posted an answer for this 1997 GMC Jimmy:
"Used: www.car-parts.com"
Rick Gillis posted an answer for this 1999 Chevrolet Venture:
"Removal Procedure Tools RequiredJ 38400 Caution: Keep fingers away from rear brake..."
Rick Gillis posted an answer for this 2001 Chevrolet Silverado:
"Hope this helps"
Rick Gillis posted an answer for this Chevrolet Cars & Trucks:
"http://www.fisherplows.com/pdf/22372_050098.pdf"
Rick Gillis posted an answer for this 2006 GMC Sierra Denali:
"The only way to get a broken tap out will be to use a punch and break it out"
Rick Gillis posted an answer for this 2000 Chevrolet Silverado 1500:
"DTC P0446 Evaporative Emission (EVAP) Vent System Performance The vehicle control module..."
Rick Gillis posted an answer for this 2003 Chevrolet Silverado 1500:
"Most likely is the resistor when they fault the default to high giving you off and high..."
Rick Gillis posted an answer for this 2000 Chevrolet Prizm:
"You most likely need a blower resistor"
Rick Gillis posted an answer for this 2001 Chevrolet Express:
"It is part of the heater box below dash on passenger side of van"
Rick Gillis posted an answer for this 2002 Chevrolet Impala:
"The traction control system uses the abs wheel sensors to detect wheel speed if the abs..."
Rick Gillis posted an answer for this 2006 GMC Envoy:
"The IAT is integrated with the MAF (Mass Air Flow) sensor all one unit the following..."
Rick Gillis posted an answer for this 1995 GMC Jimmy:
"9141 does not exist I will assume it is DTC P0141 HO2S Heater Performance Bank 1 Sensor 2..."
Rick Gillis posted an answer for this GMC Cars & Trucks:
"Could be a wheel bearing or tie rods"
Rick Gillis posted an answer for this 1991 Acura Legend:
"It could be low fluid, bad sensor or the e-brake could be on even just a bit"