That is an easy one to fix :>D
If uL (unbalanced load) appears in display, the load is out of balance. The washer is running a load-balance correction routine. Allow the washer to continue. If the dial is flashing and the washer has stopped, redistribute the load, close the lid, and press START/PAUSE.
Hi,
please reset the washer by unplugging it's power for 1 to 2 minutes before plugging the power back in and pressing start. If the issue reoccurs, please switch power outlets and try again. If all else fails, please review the troubleshooting section of your manual.
Thank you.
First unplug the washer. Next grab the seperator on top of agitator pull off then you will see a 7/16 bolt take it out then pull agitator out when reinstalling it back do it in reverse. Good Luck Mike L.
The error code F7 indicates there is a problem with the motor. It fails to get to the required speed for the wash cycle. Make sure the drum isn't too full. Also make sure all transit bolts are removed.
Something could be stuck inside of your washing machines drain or the hose could be needing to replaced or the hose could be kinked or twisted or have holes in it. Or the wires are either broken or loose in the water valve or the washing machines wiring harness and have to be replaced.