Sharp Refrigerators - Page 4 - Recent Questions, Troubleshooting & Support

Drain Try is full with water its fix on compresser. Empty Drain try and try.

No this is not possible.

Freezer Fan is not working or Gas leaked from Compressor line.

Checked any gas leaked from compressor.

Most of this problem with Freezer fuse.

Change Original Defrost Time and checked.

Switch off your ref for 8hrs till all Ice melt in freezer compartment. Switch on Ref and checked Air coming from Ref duct or not.

Switch off your ref for more then 8 hrs and checked all ice melt after that you can adjust all attachment .

Checked Damper in Ref its working or not. You can checked open Ref door press Door Switch and hold your hand near chiller tray Duct

Checked Thermostat and replaced.

Main PCB Defective

Model No required if two door you can open Glass of Lamp after that open two nut and replaced with same one.

Adjust Freezer Temp center and ref also in center

Checked Drain pipe behind ref on top Compressor is not full of water

You can checked error with pressing select button for 5 second while Ref door open. If any defect in your ref error will display.

Switch off your Fridge for 24 hrs and after that start. Before starting adjust control to minimum.

You can open 3 Screw on top and adjust door.

The hole you seek is generally to be found at the back of the fridge low down at the base of a funnel-shaped moulding in the plastic of the lining. Water droplets formed during the defrost cycle do so mainly at the back where they should be able to trickle until channeled by the funnel shape they fall through a small length of hose into a tray mounted on top of the motor where the heat will evaporate the water. If you have difficulty finding the hole from the inside then poking a wire or something upwards through the hose from the back should make it more visible as well as ensuring it is clear.

Temperature for which part?