How to set clock on sharp microwave
normally you look for the clock ot watch icon. Pressing it once will give you the option for 24 hours setting. Press it twice and it will give you the opportunity to set to 12 hours setting. Using the no. keypad, punch in the time and then repress the clock icon again.
My sharp Double Grill & Oven R795 will not heat up to temperature, when used as an oven . Microwave side is ok, can any body help
You might attempt the following troubleshooting steps:
Ensure sure the temperature settings are accurate and that you have given the oven enough time to warm before putting food inside. Check the oven temperature settings. To learn how to adjust the temperature properly, consult the user handbook.
Examine the heating components since they can be broken if the oven is not heating at all. When the oven is switched on, see if the heating components are blazing red. The heating components might need to be replaced if they are not.
Examine the oven thermostat: If the temperature fluctuates or fails to reach the desired level, the thermostat may be malfunctioning. Replace a broken thermostat if necessary.
Verify that there are no blockages inside the oven that could be preventing the heat from circulating. Debris, foil, or bakeware that is too big or that covers a significant amount of the oven rack might all fall under this category.
Sharp aquos sound bad on some channels
You have also ruled the set out if only "a few channels" as set is not smart enough to know what channel you are on--you can check all the audio settings but if a box is used for signal the problem may be there.
LC-50UA6800X with flickering vertical band
We've seen something similar in our shop on Hisense TV's, and considering Sharp sets are made by Hisence it may be related. The issue we have found was the balling of the prosessor IC was bad, a replacement main may fix it, or you can try "cooking" the board in an oven, see some youtube videos on how to do this
TV Sharp LC-40LE830U. My front panel ys disabled and my remote control don't work. I can power on/off only. How can I enable my front panel without use remote control? or reset factory settings?
If both your front panel and remote control are disabled, the best option would be to perform a factory reset to restore the TV to its original settings.
To reset the Sharp LC-40LE830U to factory settings:
- Unplug the TV from the power outlet and wait for at least 60 seconds.
- Press and hold the power button on the TV for 5 seconds while the TV is still unplugged.
- Plug the TV back in and turn it on using the power button on the TV itself.
- Once the TV is turned on, press and hold the "input" and "volume down" buttons on the TV simultaneously for 5 seconds.
- The TV will then enter the service mode menu.
- Press the "menu" button on the remote control to navigate through the menu and select "option."
- Select "factory reset" from the options menu and follow the on-screen instructions to complete the reset.
Note: The factory reset will erase all custom settings, including parental controls, picture, and audio settings.
Not finding what you are looking for?