Sears Air Tools & Compressors - Recent Questions, Troubleshooting & Support
Trying to pump up a car tire but very lo
Sometimes the air regulator will limit the air volume and pressure when drawing a large quantity of air out of the tank. The regulator was most likely designed for nailing which has very little demand. For filling auto tires you may have to bypass the regulator. If your compressor has a safety valve, with 1/4 male pipe threads, remove the safety valve and install a nipple and tee fitting (let out all the air from the tank before removing the safety valve by pulling on the ring). Reinstall safety valve on one port and a quick connect on the other. Now you will have access to full tank pressure without the restriction of the regulator when needed. Good luck
TNT XAGD50 brad nailer is jammed
If the jam is bad enough you may just have to pull the 3 front magazine screws (metric allen screws) and the one in the rear that holds the magazine to the tool frame. That way you can pull the entire magazine off which will expose the nose area and you can remove the jammed nail.
The nail gun TNT
I HAVE A TNT BRAID NAILER AND IT GOT JAMMED BUT I REMOVED THE JAMMED NAILS AND AFTER PUTTING IT BACK TOGETHER IT FIRED THE FIRST NAIL AND STOPPED FIRING IT FIRES BUT NOTHING **** OUT I DONT THINK THE DRIVER ISN'T PULLING BACK FAR ENOUGH TO LOAD THE NEXT NAIL.
Tnt brad nail wont fire
If you hear a slight discharge of air from trigger area and no fire, could be a lack of lubrication of the headvalve or safety foot is not pushing in the firing pin. If the safety foot is not pushing the firing pin, examine parts and repair as needed. If safety parts seem to be working ok, remove the head and lube headvale with silicone paste or white grease.
Not finding what you are looking for?