Sanyo Audio Players & Recorders - Recent Questions, Troubleshooting & Support
Sanyo TRC 1149 winding and playback faults
Hi,\015\012\015\012I'm sorry to hear that.\015\012\015\012This is a common fault on cassette decks and can be caused by a number of things.\015\012\015\012The most common is the motor being seized or worn.\015\012\015\012If the motor spins when you touch the belt then the problem lies in the drive mechanisms.\015\012\015\012There is a good chance that the drive belt has perished and needs to be replaced.\015\012\015\012If the deck is drawing too much current when you switch it on the fuse will blow.\015\012\015\012If the fuse is fine and the deck runs for a few seconds before cutting out then the problem could be one of the capacitors in the power supply.\015\012\015\012If the deck is more than 10 years old then it may be time to replace the capacitors.\015\012\015\012You can do this yourself if you are a little bit handy with a soldering iron.\015\012\015\012That's about it really.\015\012\015\012
Cannot play wmv or MP4 files - SANYO DMC 2040
You most likely are not meeting the specs required by the player. Check the manual on the cd for the specs the player can resolve or use the converter on the cd to convert your mp4's wmv to meet the specs.
Displays no disc when Cd is player
HelloPut it an other good known disc, which the set has played without any problem at all. If it also doesn read it, and displays no disc, the Laser Picku unit of your set has damaged. Put in a lens cleaning disc into the player, and play it for at least three times. If the fault is due to accumulation of dust or durt, the cleaning disc will clean it, and your set will be OK. If not repalce the Laser Picku Unit, sith same type and number.The lens cleanig disc can be bought from most of the electronic sparpart selling shops at your town, and won't cost more. OK.
No power sanyo r227
I had the same problem. A defective capacitor is trying to charge near the audio chip . My solution : I have remove the audio chip (the one with big heat sink) and I use the aux out output to my amplifier. When plugging it takes some time to finally work : but once plug and working it stays on and work ok.
My sanyo r227 internet radio just flashes quickly
Flashing is caused by bad capacitors Caps on power supply board all go bad sooner or later, so replace them all ($5). Look for bulging tops especially, and the green ones are the worst. Power spike could have caused poor quality caps to fail. Don't want to fix it, sell it to me.
No power sanyo r227
Could be bad capacitors or fuse. Fuse is inside under a plastic cover as I recall. Caps on power supply board all go bad sooner or later, so replace them all ($5). Look for bulging tops especially, and the green ones are the worst. Power spike could have caused poor quality caps to fail. Don't want to fix it, sell it to me.
Cal I bye a new or referb power supply board?
If you can get a refurbished power supply board, buy it. They are as good as those new from factory. I bought a refurbished Sony Radio - Cassette - CD player 23 years ago and it's still good!
Scematic for sanyo r 227
You'll never get this from them, as others have tried. Sanyo is now Panasonic (Matsushita). Also sold under the Medion name (in Europe I think).
Sanyo r227 flashes when plugged in
Most likely bad capacitors on the power supply board. Replace them all (6 or 7). Same thing happened to mine. If you see green capacitors (KSC brand) they are definitely bad. Notorious for failing. Cost about $4 for me as I do it myself. Don't want to fix it yourself, sell it to me.
What is the FM ANT and how do we use it on a Sanyo DC-DA1460M
Hello Hannes, FM ANT, is the connection of the antenna to receive FM radio stations (Frequency Modulated) Here you can connect a cable of approximately 1 meter, and use it as an antenna, depending on where you are, rural or remote areas. the city, you might need an external antenna, similar to those used for analog TV reception
I sent you a link to download the user manual of your Sanyo
Greetings Franco Dosil
Hola Hannes, FM ANT, es la conexion de la antena para recibir estaciones de radio de FM (Frecuencia Modulada)Ahi pedes conectar un cable de 1 metro aproximadamente, y lo usas como antena, dependiendo de donde te encuentres, zonas rurales o alejadas de la ciudad, podrias necesitar una antena externa, similares a las usadas para recepcion de TV analoga
te envio un link para que descargues el manual de usuario de tu Sanyo
Saludos Franco Dosil
https://mans.io/files/get/499596
https://mans.io/item/sanyo/dc-da1460m
https://elektrotanya.com/sanyo_dc-da1460m_micro_component_system_sm.rar/download.html
Not finding what you are looking for?