Robot Coupe Food Processors - Page 4 - Recent Questions, Troubleshooting & Support
Remove pin & replace in work bowl
it takes two to do this. there are two holes on the bottom part of handle. find something strong to push them in. one person pushes them in and have other person with pliers pull on the plug that you need to remove to get to broken pin. after that...replacement is easy
The machine I have seems
Hi
you can actually check the relays on the circuit board to check if it
really does it part which serves as triggering device with other
accessories.Thsi might be the problem why yuor motor sometimes does not engage.You can open the panel circuit board and check both ends
using a MULTITESTER.You have to unplug first ac source.Check the
continuity of the relay using a TESTER setting it to OHMS value.Now if
the reading kicked off to its maximum it means relay is not working
anymore..Hope this helps.
Reply
Replaced safety switch but having trouble
Hi,
Since the unit does not start even after replacing the safety switch ,please follow the below mentioned procedures:-
1. Are all the attachments tightly in place? Be sure the continuous feed lead is flush with the
continuous feed attachment. Bowl: Is the long bowl lid
tab fully in place over the handle. Try again.
2. Press the off button and unplug the unit.
3. Remove continuous feed lead or bowl.
4. Remove any product from inside the attachment.
5. Is there any product jamming the plate or the blade?
Always wear cutting gloves when
handling the plates or blades.
6. Try another outlet.
Also refer the below link which would contain the Manual for the food processor.
http://download.partstown.com/is-bin/intershop.static/WFS/Reedy-PartsTown-Site/-/en_US/manuals/R4N_spm.pdf
Thank you for your time and best wishes for your effort.
Not finding what you are looking for?