Robot Coupe Food Processors - Recent Questions, Troubleshooting & Support

To add the pulse button to your Robot Coupe R101, you will need to purchase the R101 Plus switch and front panel. The replacement is relatively simple and can be done by following these steps:

1. Turn off and unplug the Robot Coupe R101.
2. Remove the screws that hold the top cover in place and lift off the cover.
3. Locate the control panel on the front of the machine and remove the screws that hold it in place.
4. Carefully remove the control panel and disconnect the wires from the old switch.
5. Install the new R101 Plus switch onto the control panel and connect the wires.
6. Replace the control panel onto the front of the machine and secure it in place with the screws.
7. Replace the top cover and secure it in place with the screws.

Once the new switch and front panel are installed, you will have the pulse button on your Robot Coupe R101.

Pour penetrating oil down the upper shaft if possible. Remove the allen scews from the base with 5/32 T handle wrench. Remove the round snap ring on the motor shaft. Use vise grips or channel lock to secure the shaft. Twist the blade off and inspect it. It most likely will need to be replaced as the key that slides on the shaft will have deteriorated.

Left hand thread perhaps.

Wiring diagrams are in the back of the manuals after the parts lists.https://www.partstown.com/robot-coupe/blixer-3b/parts#id=mdptabmanuals..

Question moved to correct category. Page 17 onwards has the wiring diagrams https://www.webstaurantstore.com/documents/pdf/r502_r602_-_manual.pdf ..

you look for hidden screw perhaps under a label

Hi im after a replacement lid for my robot chef rc3 if anyone has a spair one please email me at [email protected]

Thanks so much for the advice. Any idea what size TORX is required?

Yes you will need to replace the machine.