Quinny Dreami - Recent Questions, Troubleshooting & Support
Missing anchor to secure carry cot on quinneychassis
HiYou can order replacement adaptors to secure your Quinny Dreami onto the Quinny Buzz / Quinny Speedi chassis.Visit www.quinny.com, select the country you're in and then choose the "Contact Us" tab on the right side of the page for your enquiry to be sent to the customer care team in your country.
Grey carrycot clip broke
Hi
If you're
in the UK
and the product is under 2 years old, please contact your retailer with your
proof of purchase and they can arrange for it to be sent to our engineers for
inspection / repair work required under warranty.
If you're in the UK and the product is over 2 years old or you no longer have
proof of purchase please contact the customer care team on 01284 413 141
Mon-Thur 8.30-6.30 / Fri 8.30-4.30 (Excluding Bank Holidays) to discuss booking
it in for chargeable inspection / repair work required.
If you're
outside the UK
please visit www.quinny.com and select the
country you're in, then use the "Contact Us" tab on the right side for your
enquiry to be sent through to the customer care team in your country.
The hood on my carrycot will not stay up how can I
Pull it all the way up when it's fully up pull it a but more untill it clicks,I hope that works for you.If not I may have been forced closed in the past and the plastic mechanism may have worn.This is what has happened to me :( I'm on here to fine a solution :) good luck.
I have been given I
Good Morning
The new Dreami will fit onto an older style chassis and likewise an older Dreami will fit onto the newer chassis.
The adaptors will not come with the Dreami, they would have come with the Buzz. If you need replacement Buzz adaptors please contact your local authorised Quinny retailer to order.
How to get mould of my quinny buzz seat cover??
I like a product called whizz mould and mildew remover have used this on many things before even on a mothercare pushchair hood but it was a waterproof hood so not as absorbent. Maybe do a spot test first somewhere inconspicuous.
New ram for quinny buzz
Be sure it is the gas ram and not the cast aluminium anvil which the gas ram pushes against. The symtoms are similar
This 'L' shaped casting snapped in half on our Quinny Buzz and I managed to repair it by taking the whole centre hinge apart, drilling out the pin which holds one half of the aluminium anvil in place and removing this striaght piece of the anvil.
To repair I first glued the two parts together with araldite then held them in the vice whilst drilling through both pieces to a depth of about an inch with a 4mm tapping size drill. Then seperate the two parts, tap the shank out 4mm and drill the right angled bit 4mm clearance. Reconnect the two parts using a 4mm steel screw and some 'locktight'. Replace the anvil in its slot and replace the holding pin securing with araldite.
Reassemble the whole shooting match and it works ( well ours did....and still does!)
This seems to be a common problem but I could not find any spares. Also the holding pin for the anvil is not made to come out hence having to drill it out. So I doubt if any spares are available anyway.
Not easy and you need a few engineering tools to do the job. But much cheaper than a new frame assembly.
Not finding what you are looking for?