Proscan Tablets & eReaders - Recent Questions, Troubleshooting & Support
Proscan tablet is frozen
Check for the reset pin hole on your tablet. Get a paper clip and push it 'gently' in the hole and hold it for thirty seconds. This resets the tablet.
Youdon't want to push hard as there is just a tiny button in there that can get dislodged.
1/3/2020 2:13:24 PM •
Proscan...
•
Answered
on Jan 03, 2020
Locked out
There should be a rest set system button , you may have to use a small paper clip unfolded to fit into the area. But that should do it. Good luck
How to reset tablets
Do a hard reset, press and hold the +vol button, then the power button, wait about 20 seconds both buttons held till the start android screen appears. Hope that helps
Measurements
Screen or outside measurements? Strange question. Why not just get a ruler?
Proscan tablet too slow
This tablet is absolutely junk.
Just throw it in the trash can.(don't forget to reset it to wipe everything off) And please don't give it to anyone, you might be sued....Haha.... Paul H
10/30/2018 1:48:42 AM •
Proscan...
•
Answered
on Oct 30, 2018
I dis a factory reset on my Proscan 8 PLT8235G tablet. Now, I can't install or update any apps. What do I do to fix this?
Not being able to update any apps simply means either you don't have access to the internet or that your apps update is programmed to function ONLY when you are connected to/through WiFi.
second, you can download standalone 'raw' apk files online and install on your tab.
Remember to go into your Settings---Security (and under Device administration, check 'Unknown sources' and activate 'allow installation of apps from unknown sources'.
Done.
This is safe.
Post update or feedback please
Proscan PLT8235G stuck on blue screen. Reset button just shuts tablet off, and problem still remains.
I have had the same issue with this tablet. After weeks of looking around on the net i have found a way to reset the tablet to factory settings when the power and vol down button will not work.
1. Download the firmware from the proscan website.
http://www.proscanvideo.com/item.asp?itemnmbr=PLT8235G.
2. unzip the file and copy the files update.zip recovery.img and factory_update_param.aml to an external micro sd card.
3. Plug the tablet in and insert the sd card. Press the power button to see the battery icon then press the power button 5 times. Then let it run for 4 minutes and it should be set back to factory settings.
****NOTE***** If it fails to update then you still have the access to the recovery menu where you can do the factory wipe and still reset it.
Hope this helps.
Not finding what you are looking for?