Peg Perego Toys - Recent Questions, Troubleshooting & Support
Throttle cable slack on piaggio et2
To adjust the throttle cable slack on a Piaggio ET2, you will need to locate the throttle cable adjuster. The adjuster is typically located near the carburetor or the throttle body.
To adjust the slack, first loosen the locknut that secures the adjuster. Then, turn the adjuster clockwise to tighten the cable or counterclockwise to loosen it until the desired slack is achieved.
Once you have adjusted the cable, tighten the locknut to secure the adjuster in place. Be sure to test the throttle to make sure it is functioning properly before riding the scooter.
Peg Perego Thomas The Train - Ride On wont go but horn &whistle works
If the Peg Perego Thomas The Train ride-on is not moving but the horn and whistle are still working, it's likely an issue with the motor or the gearbox. Here are a few troubleshooting steps you can try:
- Check the battery: Make sure the battery is fully charged and properly connected. If the battery is old, it may need to be replaced.
- Check the wiring: Inspect the wiring for any damage or loose connections. Ensure that the wiring is properly connected to the motor and gearbox.
- Check the motor: The motor may be burnt out or malfunctioning. Use a multimeter to test the motor and see if it's receiving power.
- Check the gearbox: The gearbox may be jammed or worn out. Inspect the gearbox for any damage or obstructions. Try lubricating the gears with some WD-40 to see if that helps.
If none of these steps resolve the issue, it may be best to contact Peg Perego customer service or take the ride-on to a certified repair shop.
Wheels spinning in opposite directions
the polarity is reversed on one of the motors, if the gear selecter is in low or high gear the wheels should propell the vehicle forward, whichever wheel is not propelling the vehicle forward switch the wires around on the motor
Fuel leaking from carburetor
Could be worn or sticking float valve, located in bowl of carburetor. to test turn off fuel, remove bowl from carburetor, gently raise floats all the way with finger, turn on fuel, it should not leak until released.
Trouble starting my vespa
check your takn and clean your fuel and air filter and check the fuel line from the tank to the carb and blow it out, 1 of these should help.
Not finding what you are looking for?