Mitsubishi Heating & Cooling - Recent Questions, Troubleshooting & Support

Indoor unit indicator RUN lamp = 6 time flash TIMER lamp = Comes on Outdoor unit indicator (LED5) = Stays off Description of trouble = Indoor fan motor error (2) Cause = Defective fan motor, Connector poor connection Conditions of flashing = When air conditioner is operating and indoor fan motor is turned ON, indoor fan motor speed of 400 rpm or under continued for more than 30 seconds. (Air conditioner stops.)

I had the same problem and I found it was that another unit had the heat running while I was trying to run AC on another (they're both attached to the same condenser) so it could only run heat or AC not both. Turn off the heat!

The blinking is an indicator that it needs service. Call a technician! Ask if they are experienced in mini split systems. You can check the air filters. Check the outdoor coil to see if its clean or covered up with dirt. And at the breaker or disconnect, turn off power, wait 5 mins, and turn it back on. Then give it 3-5 mins to see if it will reset itself. If this don't work, call a tech/service provider! These units are troublesome to troubleshoot.

Panasonic non inverter ac 2time power light blinking

either ask Mitsubishi or GOOGLE

Question edited for clarity. Question moved from Mitsubishi Cars. SRK 35 is only part of the model number according to my online research, 'zs' plus a further letter zs y and others. https://www.google.com/search?q=mitsubishi+srk+35+wifi+module ..

If unit is new why are you trying to fix it. Personally I would call for service under warranty. Have you contacted the company that installed it?

Not very practical unless you find a donor (identical) vehicle fitted with aircon and even then changing all the parts over would be a considerable amount of work even though a huge saving of cash.

Does your have remote control? The original remote control has heating funtion. https://www.remotesus.com/for-mitsubishi-ac-remote-control-for-mitsubishi-air-conditioner-msd-cd07vd-kf-23ge-for-mitsubishi-remote-control-display-in-fahrenheit-p3042690.html

call back installer

I Have same problem

Switch the polarity of the control voltage...make sure it matches with the indoor & outdoor unit

It’s on the data plate. Typically on the bottom of a wall hung, behind the filter door on ceiling cassette. Condenser is obviously on condenser outside.

CALL A REPAIR SERVICE LOCALLY

Possibly water in the disconnect or wet control board. Be sure system sealed up outside properly. Allow to dry and try again.

A failing thermostat is the most likely cause. Once the temperature is below the set-point, it should come back on, called up by the thermostat.

An EO error indicates an electronic error caused by either a control board problem or a problem with supply voltage to the heater. A single EO code is not cause for concern, but for repeated EO codes

Check the code to see what that one means. The codes are on the inside of the indoor unit cover. See this link to find them. https://www.visionair.com.sg/blogs/news/what-does-it-mean-mitsubishi-electric-starmex-blinking-lights

Could be a defective relay in the outside unit

************* Real answer here***********

Wow no one here answered the question how is it solved lol