Kubota Garden - Recent Questions, Troubleshooting & Support
Wiring d irections for kubota 2350 tractor. Signal and tail lights
, I figured the rear lights replacement out. going through the fender there is a protective loom cover. (ridged black plastic) very carefully pull this up and out. when you get it all out you will have to (one at a time) pull the plug ins through the fender hole. then you can access the plugs to install the new wiring to them and install the lights. the left fender is easy. the right has the fuel cel in the way so i found that cutting off the wires to each light, one at a time. and pulling it down and using a wire puller. I pulled the new wires down to the bottom of the fender and plugging them in one set at a time. then it was just a matter of pulling the wires back up in place and replacing the loom covers. I did remove the red fender light to help me see that the wires were not tangled when pulling them back up.
Hope this my help someone else that may need to replace those rear flashing lights on the rops bar.
on Oct 30, 2019
I have code P0093 on a L6060 Kubota tractor
The code P0093 indicates a possible a major fuel leak. It is possible that too much water in the bowl may have triggered this error or a dirty fuel filter. Look for leaks. You can change the fuel filter, and check the RETURN line to the tank to make sure it is not pinched or blocked. Then disconnect the battery to try to reset. If it still has the code, see if any sensors have gone bad. .
I hope this helps!
on Sep 09, 2019
Not finding what you are looking for?