KitchenAid Microwave Ovens - Page 2 - Recent Questions, Troubleshooting & Support
KITCHENAID MICRO/OVEN COMBO, EVERYTHING WORKS (CLOCK, TIMER, LIGHTS, OVEN) EXCEPT THE MICROWAVE. IF I TRY TO USE THE MICROWAVE I GET A "DOOR" MESSAGE DOOR IS CLOSED BUT IT ONLY BEEPS AND SAYS DOOR.
Hi Jill, what the screen indicates is that the door is not closed
There are a number of internal contacts that have to be closed for the microwave to work
If any of them are wrong, they can give you that information.
Depending on the brand there may be between 2 or 3 contacts in the door area that generate that warning
Indicate brand, model and type of equipment you are commenting on, in order to find the best possible solution
I wait your answer
Regards Franco Dosil
Hola Jill, lo que te indica la pantalla es que la puerta no esta cerrada
Hay una serie de contactos internos que tienen que estar cerrados para que el microondas funcione
Si alguno de ellos esta mal puede darte esa informacion
Derpendiendo de la marca pueda haber entre 2 o 3 contactos en la zona de la puerta que generan ese aviso
Indica marca, modelo y tipo de equipo del que estas comentando, para poder encontrar la mejor soluci?n posible
Espero tu respuesta
Saludos Franco Dosil
I own a KitchenAid KEHC309JSS05 and the microwave
common problem with lots of MWs - the door switches are not set and secured properly. Now they are totally off. Need to pull apart and reset. Not a task for an average homeowner. Mine (Whirlpool) did that 1 week after I got it - exchanged for a new one.
Code F6, E0, "Communication Error"
Hi. this code represents a key pad or control board malfunction. you will have to make sure the key pad or control panel connectors are connected tightly and securely. If the wires and connectors are secure, the actual control board may be faulty and you will need to replace it at this point.
Kitchenaid microwave oven KBMC140HSO
I started having the same problem with my KBMC140HSSO. You cannot see the error codes without disassembling the control panel (the codes are on another display that covered by the front panel). After doing so I found the error code to be F2, E3 which is "Key held down too long, or key shorted". I am ordering a replacement keypad and will report back if this fixes the problem.
Need to Replace Door Handle for KitchenAid Over Range Microwave Hood Combo KHMS147KSS
Chances are the door panels separate as shown in the photo I have attached below.
Panel replacement can usually be done without removing the door from the microwave.
In cases where it is felt that door removal is necessary, I recommend detaching the door from the hinges.
I generally do not advise removing the hinges from the microwave.
Whenever the hinges are removed, great care must be taken to put them back in the very same position they were in.
Failure to do so can cause microwave leakage, which can cause risk of skin burns, fire, and disruption of nearby electronic devices.
You can find exploded view diagrams and order parts here: http://tinyurl.com/gv383
We have critical safety and disassembly info at our site, which is linked at our listing here on FixYa: http://tinyurl.com/yzjozk
Replace door handle kitchenaid microwave KHMS155L
Here's a diagram of the door. On the inside of the door is the frame, #2. This can be removed very carefully with a small flat bladed screwdriver and work slowly around. The frame is held in place with plastic tabs on frame. Once frame is removed, you should see the two screws that hold the handle in place. Good Luck!
Is it worth fixing our 9 year old above stove microwave Kitchenaid YKHMS2050SS - 2? Random beeping and now not heating.
I'm sorry to say that it's most likely the magnetron that's shorted out (the high voltage device that produces microwaves). It's usually the case with ovens this old that a compatible replacement won't be available.
There's also the fact that your oven is likely way past it's 'end-of-life' date so even if you could find a replacement, other components will begin to fail as more time passes.
In short, save yourself the money, time, and frustration with a new unit. Good luck!
Not finding what you are looking for?