Kenmore Logo

Kenmore Recent Questions, Troubleshooting Help & Support

Do you work here? Claim your company

  • 3K Products
  • 244K Answers
  • 4M Views

Hello. The closest model to the one you say you have is
79092702011... There is nothing on the sears website remotely close...The elements, if this is the real model you have, are as follows:
bake...316505500
Broil...316203301
I hope this helps you...

Kenmore Ovens | Answered on Jan 24, 2020


Hello. There are several things that can cause this problem. The first thing I check is the drain pump--if there is 120 volts getting to the pump, and the pump is not running, the drain pump is either jammed or the motor is bad. If there is NOT 120 volts at the pump when it should be running, that indicates either a broken wire from the main control board or, a defective main control board. If the unit senses water in the tub, IT WON'T SPIN. One of the other causes of a no-spin could be a defective lid lock or even a corrupted/damaged main control board. The drive motor for the unit is controlled by the main control board which is told what to do by a program. If you have power outages, the board could have been partially damaged by a current surge when the power was restored. (Outages are NOTORIOUS for damaging circuit boards in appliances). If it wasn't blown out immediately, USUALLY about 4-6 weeks after the event the chips on the boards start to fail causing varied problems.

Kenmore Washing... | Answered on Jan 24, 2020


Make sure lint trap is clean and air vent line is clean if they are it might be a sensor but you don't want a fire good luck

Kenmore Dryers | Answered on Jan 19, 2020


A lot of Kenmore toe grilles (kick plates) are just snapped into place on both ends. The photo is from another Kenmore model but it might help on yours
kickplate-undefined-undefined-0.png

Kenmore Grilling | Answered on Jan 16, 2020


u more than likely have to remove the bottom plate first and the screws along the back wall are most likely covered with a plastic covering

Kenmore... | Answered on Jan 14, 2020


Sounds like the wiring to the element and a bad connection. Pull the machine out and lean it up against the wall. Make sure it is leaning well and won't tip forward. Look up underneath with a flashlight.

Kenmore Washing... | Answered on Jan 13, 2020


What about it?

Kenmore Dryers | Answered on Jan 13, 2020

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Kenmore Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

john h

Level 3 Expert

22486 Answers

Gil Shultz

Level 3 Expert

3388 Answers

Are you a Kenmore Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...