John Deere Garden - Recent Questions, Troubleshooting & Support


1945: 542700
1946: 555334

Tractordata.com

Shows year of mfg as 1945.

John Deere... | Answered on Dec 02, 2019


The oil inside for the reverser is good? You found that the oil level was correct, the fluid was clean and no further actions were needed? Usually the failure is the clutch pack but that is seen in the fluid. Can you feel or notice that the shift lever is moving into the gear selection correctly? Do you notice, feel or hear that reverse gear is engaged when selected. Do you hear any noises or sounds that weren't there before the failure? Did this failure happen out of the blue or have you noticed reverse acting up for a while now? Please let me know. Good luck.

John Deere... | Answered on Dec 02, 2019


Order the service manual from John Deere.

John Deere... | Answered on Nov 30, 2019


Request the diagram from John Deere.

John Deere... | Answered on Nov 30, 2019


Request a starter wiring diagram from John Deere.

John Deere... | Answered on Nov 30, 2019


Request the diagram from John Deere.

John Deere... | Answered on Nov 30, 2019


Request the wiring diagram (not a schematic) directly from John Deere.

John Deere... | Answered on Nov 30, 2019


There are video's of how to do this on u tube .

John Deere... | Answered on Nov 28, 2019


Search for part AM106852 but not sure its wise to spend over $100US on a carb for a 15 year old machine. Problem could be crankcase leak.

Should be able to find a different source for under $30. Look for numbers stamped on the carb and internet search those numbers for a different source.

John Deere... | Answered on Nov 19, 2019


IM SURE DEERE SUGGESTS THEIR OIL BUT ANY GOOD SYNTHETIC 2 STOKE OIL IS FINE

John Deere... | Answered on Nov 12, 2019


My guess is water in fuel.

You can verify fuel issue by removing air filter and spray a short 1 second burst of starter fluid into carburetor and promptly crank engine. If it's a no fuel in carb issue it will fire and run a few seconds until starter fluid is expended.

Disconnect fuel line at carburetor and capture sample (cup or so) while cranking engine.

Put sample in a small clear glass container. Look for an obvious horizontal line... fuel floats on water. Any sign of water and youll need to drain the tank AND carburetor bowl.

Then get fresh fuel in a clean empty container... dont use what you might have.

Comment here and I'll assist further I'd not a fuel issue.

John Deere... | Answered on Nov 09, 2019


http://manuals.deere.com/cceomview/OMM146413_G1/Output/146413g112.html

John Deere... | Answered on Nov 05, 2019


For a place to start...

https://partscatalog.deere.com/jdrc/search/type/model/term/2020

Select your model an look over parts diagrams.

If you have a more specific question, please comment here.

John Deere... | Answered on Nov 04, 2019

Not finding what you are looking for?
John Deere Logo

9,370 questions posted

Ask a Question

Usually answered in minutes!

Top John Deere Garden Experts

Dave

Level 2 Expert

101 Answers

Joseph Mueller
Joseph Mueller

Level 2 Expert

346 Answers

john h

Level 3 Expert

22486 Answers

Are you a John Deere Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...