Hobart Kitchen Appliances - Others - Recent Questions, Troubleshooting & Support
HOW TO CHANGE DRIVE BELT. ON HOBART MEAT SLICER 2712
To change the drive belt on a Hobart meat slicer model 2712, follow these steps:
- Disconnect the slicer from the power source and remove the knife and knife cover.
- Remove the slicer carriage by loosening the two carriage mounting screws and lifting the carriage off the slicer.
- Locate the drive belt on the slicer and identify the tension adjustment bolt.
- Loosen the tension adjustment bolt to release the tension on the drive belt.
- Remove the drive belt from the slicer.
- Install the new drive belt onto the slicer, making sure it is properly aligned on the pulleys.
- Adjust the tension on the drive belt by tightening the tension adjustment bolt.
- Reinstall the slicer carriage and the knife and knife cover.
- Reconnect the slicer to the power source and test the drive belt to make sure it is functioning properly.
I hope this information is helpful. If you have any further questions or need additional assistance, don't hesitate to ask.
Have a Hobart model 4332 meat grinder. started running in reverse. why? which wires to reverse this?
Hobart motor running backwards
Got called out on a single phase mixer throwing sparks, and belts.
Found motor running backwards (single phase 230v) and a chit load of these hanging out.....
Not sure where those go, doesn't seem to be missing any parts on the stator. I pulled the head and fished these out, they were laying on the windings, and some were on the shelf of the mixer body like they were placed there on purpose. Customer says motor was rebuilt 6 months ago by a hobart dealer.
Any thoughts???
Member of the "Work Exchange Program"
"Will work for knowledge"
"Everyone is a genius. But if you judge a fish on its ability to climb a tree, it will live its whole life believing that it is "
A Einstein
Would have to be the shading pole "winding" on the stator?
think a mixer is going to have a motor with higher starting torque. Are there brushes in the motor cause those look like part of a brush lifting mechanism on a repulsion start induction run motor.
beachtec
What model is it?
mixer with belts. Is it a 1460?
Anyone have the wiring Scematic for Hobart 2912
Schematic is located on the back side of the bottom cover. Tip the slicer back and remove the bottom cover to find it. It's usually very dirty with food and, more importantly, oil. Be careful wiping oil off as the schematic often times smears when doing so.
Not finding what you are looking for?