Hitachi Drills - Page 5 - Recent Questions, Troubleshooting & Support
Speed control switch
You can find an Authorized Service Center near you on Hitachi's website (
www.hitachipowertools.com) to see if they have a switch to sell you. Another optioin is sites like
www.ereplacementparts.com where ou can do a search on your model number and find your switch. They do have your switch available (PN 333640) for $38.70 +S/H.
Hitachi dv18dvc drill just stopped battery fine
You can test the battery by using a voltmeter. Set the voltmeter to DC and to read up to 20 volts.If its getting a reading, then the trigger switch most likely shorted out. If not, then the battery is defective.
How to remove chuck from hitachi d10vf
Remove the left handed screw from inside the chuck then lay the machine on it's left side, fit a suitable spanner onto the slot behind the chuck and arrange it so that the spanner is against the work surface. Put the chuck key into the chuck and give it a hard blow so you knock it in an anti clockwise direction. If it is a keyless chuck or you don't have a key try holding the short end of a large allen key in the chuck and knock the long end in a anticlockwise direction. This will work even if you don't have a spanner to fit behind the chuck but you might have to hit it harder. If you have a vise after removing the screw hold the chuck in a vice and fit the spanner behind the chuck and turn it anti clockwise.
Not finding what you are looking for?