Hilti Hammering - Recent Questions, Troubleshooting & Support
Chisel broken in chamber how to repair and get it out
A dangerous work wear safety glasses and a
leather apron because there could be metal pieces come off the parts , make first the part the disassembled toolholder hot with a large gas burner and in a bench vise with a hammer Interim anything like WD40 spray. sometimes it could be a long prolonged work if you have inserted an invalid chisel.
2/1/2019 10:37:10 AM •
Hilti TE...
•
Answered
on Feb 01, 2019
I have a te 500 it not knocking at full strength
A Broken front ring which blocks the lock bolt ?
Is there enough lubrication flow if something is broken inside replace ALLWAYS a complete servicekit , because its , beware of the Turmopol oil is expensive. there are equivalent oils if you asked special for it also by Hilti to buy.
Hilti and Duss are not the 2 cheapest brands of powertools.
Special Tolerance-free bearings are used it is all super calculated on a number of operating hours and about if something is defective, a complete overhaul is necessary.
These hammers may leak no trace of oil in the front until 2006 HILTI has in my Country support , but after this date
exclusively support to the end-users and support closed for brokering.
Who to call for warranty
Go to the hilt I web site, it will give nearest service centre. If under warranty just call them.
5/3/2014 9:40:20 PM •
Hilti TE...
•
Answered
on May 03, 2014
Not finding what you are looking for?