Frigidaire Dryers - Recent Questions, Troubleshooting & Support

Just remove the cash box and run money through it as needed. Or you would have to remove it, and then you will find two electronic contacts or wires that you need to join together. After doing that, you would have to make sure the contacts were not exposed and safe from water.

Frigidaire... | Answered on Nov 19, 2019

Start simple. Check for the basic things that will not let the dryer run. Broken door switch. A loose wire on the door switch...those kinds of things. The same would apply to the start button. R

Frigidaire... | Answered on Nov 11, 2019

in don't know. perhaps the system resets itself. consider unplugging from electrical source. push start open and close.push stop if there is one to push. reconnect to power source.

Frigidaire... | Answered on Oct 29, 2019

I had this same issue. My dryer would run and heat up but then stop and give me the f40. I measured all thermisters and everything was in range. The tech sheet stated that I needed to buy a new control board and I did. Same problem.
The solution was a loose connection on for p4. I took needle nose pliers and squeezed the connector to make it fit tight on the board and everything is working now.
Bottom line, expensive dryer with cheap connectors.

Frigidaire... | Answered on Sep 30, 2019

AD is not an error code i found this out by goin to the frigidaire web site it just means that the dryer is in auto dry mode.

Frigidaire... | Answered on Sep 19, 2019

click on the wiring link under the
Manuals & Care Guides for FEQ1442ES1
and this will explain how to decipher the flashing lights.

Frigidaire... | Answered on Sep 10, 2019

There are several websites with error codes listed. I have not seen any codes listed for frigidaire dryers. So I checked at had no luck there either. 800-374-4432 is their customer service number. I found codes for Frigidaire cooking products but nothing for dryers. Good luck.

Frigidaire... | Answered on Jun 18, 2019

Can o still use the dryer with the E68 code
Or is there a risk of fire ?

Frigidaire... | Answered on May 30, 2019

The code E68 indicates that a button is stuck. Check the buttons by pressing them one by one to find the stuck button.

Frigidaire... | Answered on May 30, 2019

The E9X codes all point to a faulty control board, as does the fact that the PF code canno tbe cleared. Just make sure none of the buttons are stuck down before you replace it...copied from another forum im in

Frigidaire... | Answered on May 29, 2019

Sound to me like you need to check the vent for proper air flow. Make sure the pipe to the wall aint kinked. Take it apart and clean it up real good. My homemade crappy movie;

If you need further help, reach me via phone at

Frigidaire... | Answered on Apr 23, 2019

Not finding what you are looking for?
Frigidaire Logo

4,769 questions posted

Ask a Question

Usually answered in minutes!

Top Frigidaire Dryers Experts


Level 3 Expert

85223 Answers

John Tripp
John Tripp

Level 3 Expert

4656 Answers

Gerry Harvey
Gerry Harvey

Level 3 Expert

1481 Answers

Are you a Frigidaire Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides