Euro-Pro Irons - Page 4 - Recent Questions, Troubleshooting & Support
Iron shark g1468n doesn't work
If it's completely dead (no lights or anything) then check the fuse in the plug by placing a new one in (same rating, probably 13 amp) and testing. If it's not that then suspect either the heat control (thermostat) or the element. These aren't your basic DIY things to mess with unless you know what you are doing.
I love my iron ! How I can use in Israel?
The voltage in Israel is 220 volts. Check the information plate on your iron to see if it will operate on 220 volts. If it will, then you will only need an adapter from the two round pins to a two slot receptacle that you can plug your iron into. If your iron will not use 220 volts then you will need a 220/120 volt transformer with a 1 and one half times larger wattage rating on it than watt rating on your iron. Our iron is 1200 watts. We would need a 2000 watt transformer. On Amazon they cost eighty nine dollars and weigh 29 pounds. And they ship them overseas. Best of Luck
The power cord on my
Hi!!
It should be an access plate fasten by a couple of screws right below the power cord, remove them and fix the cord's terminals/contacts or the cord itself.
Good Luck!! A HELPFUL - 4 THUMBS - rating for this solution would be greatly appreciated. Thank you for using FixYa.
Iron will not stay on
More than likely your power cord has a broken wire. Plug the iron in and mover the cord around. See if you can find the broken wire. Typically where the cord comes out of the iron and right at the plug. Or replace the whole cord. Your local hardware store, youtube, or menards can show you how. Very easy to do. I tend to stay away from home depot.
Steam tank
Make sure the iron is turned off. Then pour water in the opening to the tank untill it is about 1/2 full. then put the lid on the tank.
I have a Shark automatic
you prolly have a 1 year warranty, return it to walmart or they will have the address of the local repair depot or contact shark for the local repair depot they use
I can't believe you charge
on this and any iron that requires water use
distill water it is free of minerals that way your iron is always clean and free of any sediment.
Not finding what you are looking for?