Euro-Pro Irons - Recent Questions, Troubleshooting & Support


Your Euro-Pro iron is defective and needs to be replaced.

Euro-Pro Steam... | Answered on Apr 26, 2018


-Most likely time for New one.


Good luck


Mai

Euro-Pro Shark... | Answered on Jan 11, 2018


-Make sure dial or slide control switch to the correct position.
-Make sure there is water in the reservoir.


Good luck

Mai

Euro-Pro Steam... | Answered on Jan 11, 2018


I would get a new iron. It is eight years old.

Euro-Pro Shark... | Answered on Jun 28, 2017


Hello :

1:Clean your steam iron according to the manufacturer's instructions. Your iron is more likely to leak when it has not been cleaned properly. Plus, the water that leaks from a steam iron that hasn't been cleaned will likely be dirty and stain your fabric. Every steam iron brand is different, so be sure to check the manual that came with your iron or browse the manufacturer's website for instructions on keeping your steam iron in good working order.

2:Use your steam iron on a rigid surface like an ironing board. In a rush, you might be tempted to quickly iron a blouse or pants on the nearest available surface like a bed, carpet or even on a table with a towel draped over it. However, these surfaces may not provide the proper amount of level padding for successful steam ironing, and leaks are more likely to occur. Take the time to set up your ironing board for smooth steam ironing to reduce water leaks on a bumpy surface.

3:Allow your steam iron to heat fully in the upright position before ironing. Because your steam iron is designed to convert water into steam that will easily smooth out wrinkles on bulky fabrics, you can avoid leaks by ensuring your iron has time to get the water to the correct temperature. If you lay your steam iron in the horizontal position too quickly, water that is not hot enough to convert to steam will leak. Give the iron a chance to heat up, and then test your steam function on your ironing board cover or spare fabric swatch before tacking your favorite blouse.

4:Turn off the steam function on your iron when ironing at lower temperatures. Since your iron's steam function is designed to convert the water in your iron to steam at the right temperature, lower iron temperatures can cause water to leak if your steam setting is still activated. For ironing more delicate fabrics, turn off the steam to avoid water leaks.

PLEASE RATE !

Euro-Pro Shark... | Answered on May 01, 2017


Free User Manuals and Owners Guides ManualsOnline com ,not sure if this site will help you out but have a look

Euro-Pro EP5100... | Answered on Nov 05, 2016


this iron has had it . it has rusted throuh the element and the rust s iron oxide . .. not repairable .. // replace it . as it will cost less .. mm

Euro-Pro Shark... | Answered on Jun 27, 2016


I think you have a tank that is calcified and is not getting enough heat to the water assuming there is enough water in it. If it was blocked it would either cause the relief valve to vent or explode.

I would start by cleaning it, my best guess would be to run a few cycles with vinegar in it. This is a mild acid that will dissolve the calcium deposits. Try maybe a 50%-50% with vinegar and water.

Be sure the vinegar will not damage the unit, I do not know.

Hope these links help.





http://www.sharkclean.com/manual/EP965-instruction_book_0701A.pdf

Euro Pro EP965 Use And Care Instructions Manual

Euro Pro EP965 Carpet Cleaner User Manual

Questions Answers for euro pro steam cleaner iron

Euro-Pro Irons | Answered on May 29, 2016

Not finding what you are looking for?
Euro-Pro Logo

407 questions posted

Ask a Question

Usually answered in minutes!

Top Euro-Pro Irons Experts

Brad Brown

Level 3 Expert

18157 Answers

Bruce Showalter

Level 2 Expert

133 Answers

Sheldon Dedek

Level 3 Expert

909 Answers

Are you an Euro-Pro Iron Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...