Dewalt Drills - Page 7 - Recent Questions, Troubleshooting & Support
Which is the voltage input? 110v? or can be use
If you are talking about the battery charger it is 120 volts AC. Do NOT try and use a higher voltage as you will damage the charger and it is dangerous.If you turn the charger over there is a decal on the bottom with the specs which will show it as 120 volts.
How to change bit on drywall rooter dewalt
ROUTER????you should have two wrenches or one with a locking mechanisms on shaft----loosen nut----push bit in then pull out!!!
if doesn't work take the nut off and check the holding collar---possibly spray it with penetrate---tap it a few times & it should come out------GL
My chuck on my dewalt 18 volt comes undone in reverse its fine going forward what would be the problem
If you look at the end of the shaft on the drill after it unscrews, there will be a hole with threads inside--if not the screw may have broken off---your missing screw that holds the chuck on--it's a left handed threaded screw---it's head may be slotted--philips---torx---or allen---this is available at your Dewalt dealer or tool repair---all that needed is the size/model number of unit---screw the chuck back on tightly then open chuck jaws all the way then put the holding screw in---tighten it down---REMEMBER IT'S LEFT HANDED----GL
Not finding what you are looking for?