Delta Plumbing - Recent Questions, Troubleshooting & Support


try turning off water supply then open all faucets to let then bleed down then close them and turn water back on should be ok

Delta Plumbing | Answered on Dec 24, 2019


The vacuum breaker could be defective.

Delta Plumbing | Answered on Oct 12, 2019


  • Solid Blue - Normal operation, "Touch" mode is activated.
  • Flashing Blue - Normal operation, the hands-free mode is activated.
  • Solid Red - Warning mode - Replace batteries as soon as possible. While the water is running Solid Red LED is illuminated. When the water is off, the Red LED flashes once every 5 seconds. The faucet operates normally, solenoid valve is open.
  • Rapid Flash Red - Alert Mode - Battery Failure Imminent. The Red LED flashes once a second. The first time the faucet is used, the Red LED will turn ON, the solenoid valve will be opened and remain open. The manual valve must be used until the batteries are replaced.
  • Solid Red - Lockdown Mode - Replace Batteries. Extremely Low Batteries - The RED LED is ON, and water will not flow. The solenoid valve is closed and faucet will not operate until batteries are replaced.
  • Long Flash Red (2 seconds on / 2 seconds off) - Board error, replace electronics kit, RP53230 See manual bypass of electronics section of Installation instructions.

Delta Plumbing | Answered on Aug 21, 2019


https://www.deltafaucet.com/files/live/sites/delta/files/company/concierge/Touch_troubleshooting_guide.pdf

"Ifthesesolutionsarenotabletoresolvetheissue,pleasecontactourDeltaTech2O ConciergeTeamat1-844-923-5368

IFNOSOLUTIONABOVERESOLVESTHEISSUE,PUTFAUCETINMANUALMODEBYUNPLUGGING THEBATTERYBOXWHILETHEWATERISRUNNINGUNTILRESOLUTIONCANBEACHIEVED"

Delta Plumbing | Answered on Jun 09, 2019


You need to install the screw that came with item, it goes under the handle thru the extension and into cartridge. Refer to instructions.page 3.
qk5krxajihraoapoi3zsan40ueqbvcpnowdvswq5rplcc5jjjt9xtd0q73fiheilr206ekaef1bbswnqkaf4ggaabui7kgbwcaadeaaaafvpkvylsawb+ibgaa+ig8cwcqbqibaaa6yjjomwucgc8qdqaaaabebkqdaaaaajeb0qaaaabazea0aaaaabazea0aaaaarazeawaaaacradeaaaaaqgranaaaaaaqgranaaaaaeqgramaaaaakqhraaaaaebkqdqaaaaaebkqdqaaaabebkqdaaaaajeb0qaaaabazea0aaaaabazea0aaaaarazeawaaaacradeaaaaaqgranaaaaaaqgranaaaaaeqgramaaaaakqhraaaaaebkqdqaaaaaebkqdqaaaabebkqdaaaaajeb0qaaaabazea0aaaaabazea0aaaaarazeawaaaacr8f8dkgsefmplxo4aaaaasuvork5cyii=
https://media.deltafaucet.com/MandI/88723%20Rev%20B.pdf

Delta Plumbing | Answered on Jun 05, 2019


seems like any dirt that gets in it may cut grooves in the disks and that is inly fixable by replacing them

Delta Plumbing | Answered on May 19, 2019


Take handle off it has set screw that holds it on top of faucet after handle is off it has a locking collar they may have it to tight you can get a little wrench from hardware store that turns it. most are plastic so be careful if you try to move it you may try a little at a time to see if it free's up.

Delta Model 470:... | Answered on May 15, 2019


Open the battery case and realign the batteries with the positive and negative poles in the right positions according to the layout in the battery compartment. Close the battery compartment. Make sure it locks completely before continuing.

Locate the reset button, if any, on or near the battery compartment, after changing out batteries.

Push the red reset button to reset the faucet.

Test the faucet to ensure the reset corrected the problem.

Tip
Not all automatic faucets have red reset buttons. Some faucets just require inserting new batteries or realigning the batteries in the compartment to complete a reset. on the faucet. Check the instructions that came with your automatic faucet or locate the user's guide online at the manufacturer's website.

Delta Plumbing | Answered on May 08, 2019


There is normally a filter at the end of the faucet outlet. They usually unscrew. its usually a fine mesh screen with a plastic backing mount.

Delta Plumbing | Answered on Mar 22, 2019


Try tightening the allen set screw behind the spout "you need a special (allen keys) to do this, and one should have came with your faucet". You can also buy or borrow an set of them.
http://www.efaucetscomplete.com/SpecSheets/T2755CBLHP_Install.pdf
Copy and paste this to your address bar for directions.

Delta Victorian... | Answered on Mar 06, 2019


rebuild it. buy a kit

Delta Plumbing | Answered on Jan 26, 2019


My recommendation is to reset the LED light wire and battery pack. To do this, disconnect the LED light wire from the solenoid. Disconnect the battery pack and wait a full minute. While you are waiting a full minute, you can check batteries to see if they are in good condition, even try new batteries. Make sure all batteries are in the correct direction and are tightly secured in the battery pack. After a full minute, reconnect the LED light wire into the solenoid and then reconnect the battery pack. Wait another full minute. After the full minute, you can then check your faucet and see if the lights work . If this procedure does not fix your issue, contact Delta Customer Service at (800)345-3358 Monday-Friday, 7am-7pm, CST and Saturday, 8am-5pm, CST. You may also email them at customerservice@deltafaucet.com.

Delta Plumbing | Answered on Dec 23, 2018


Just buy a new one, don't waste money and tine,

Delta Plumbing | Answered on Dec 08, 2018

Not finding what you are looking for?
Delta Logo

424 questions posted

Ask a Question

Usually answered in minutes!

Top Delta Plumbing Experts

Thomas F. Schneider

Level 3 Expert

2715 Answers

john h

Level 3 Expert

22486 Answers

Mike

Level 3 Expert

4368 Answers

Are you a Delta Plumbing Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...