Dean Music - Recent Questions, Troubleshooting & Support
Battery wire location
First you have to remove all backing plates...Wire feeds through the small hole running from battery area and attached to the volume/treble dials...then to the pickups..Everything is soldered to the switches....If you plan on removing them you will need a soldering gun and silver soldering wire...It takes a steady hand and good vision to do this....I recommend a magnifying glass and or glasses....
My red wire from battery became un soldered where dose it go
It should be easy to identify because of the solder where it was connected...You should notice at first glance....However the red wire jumps to another..Sometimes there are 3 to 4 red wires that all run from the main pending on the pick-ups If you have more than one there will be more than one wire...Look closely with a magnifying glass I'm sure you will see it...Follow all red wires until you see the small lump of solder where wire was broken from...Normally when this happens there are still a tiny piece of the wire stuck inside of solder...
No sound from dean bass
Check battery. There is a small circuit board that is not attached to anything except a few very fine wires. These came loose on mine and no schematic is available. I trashed mine and bought a Fender Jazz. sorry
Not finding what you are looking for?