Bulldog Deluxe 500, remote not starting the the vehicle
Remove the battery in your remote for 15 sec, then put back in, start your car with your key, wait 15 sec, while the car is running press the * star button 2 times, it should beep , if not try it again, if still nothing post me back and we can go from there
Starter stay engaged after it starts
If your starter stays engaged after the vehicle starts with the remote starter then, the vehicle's starter wire is receiving 12 volts, most likely from the remote starter's ignition or accessory wires. Check the connections to the vehicle's wiring: the battery wire is constant 12 volts, regardless of key position. The accessory wire(s) is 12 volts with the key at accessory and on/run (position 1 & 2), the ignition wire(s) is 12 volts with the key at on/run and start (position 2&3), and the starter wire(s) is 12 volts with the key in the start position (position 3) ONLY. Make sure that the remote starter wires are connected to vehicle's wires as directed by the Bulldog instructions.
I believe eveything is hookep
it's obvious, you don't have it wired up corectly either via grounding or via power suppply. it's blowing the fuses because you're prboably pulling too much amperage. you'll need a multimeter to see what levels of voltage and amperage and resistance are registering.
Installing a bulldog security keyless entry
hello
u will find a lot of wiring diagrams and circuit diagrams help books and stuff like this at online places.. like reliable-store
for free
the girl in the chat box can help u instantly... im a frequent buyer there since Im a mechanic so take help from there
I have a Bulldog Model 500 remote started
I take help from online websites that have this service like helping in repair some like reliable-store have instant help.. others are a bit slow which I don't prefer... rest is up to u.. U get free manuals
Just installed one. was
i have a chipper and it started giving lot of problems 4 yrs ago, so I got this free Pdf manual from reliable-store for free and I don't think Ive visited a mechanic or fixya for help for more than 3-4 times out of the 20 times I fixed the chipper in these 4 years
My 95 nissan altima will idle fine but
Were you getting bad fuel pressure readings at the manifold? Just curious what prompted you to change fuel pressure regulator and filter (nothing wrong with that of course).
I would recommend first checking the TPS (Throttle Position Sensor), second the EGR Valve and third the Catalytic converter.
Also, are you getting a CEL and any problem codes?
Installed a remote starter in a 2006 Chevy
The issue is the frequency of the remote control
often they will have a selection switch to change
the frequency. If not the remote & receiver need
to have chips changed to adjust the frequency
so they do not conflict with the vehicle system
1/20/2018 11:03:36 AM •
Bulldog...
•
Answered
on Jan 20, 2018
Keyless control not working
if you have one remote press and hold the #1 button (lock) for 10 seconds. and within 10 seconds press any of the buttons and the remote will be programed.
5/28/2014 2:27:31 PM •
710 P...
•
Answered
on May 28, 2014
Not finding what you are looking for?