Welding Tools - Page 8 - Recent Questions, Troubleshooting & Support


SUGGEST YOU TRY TO LOCATE THE MFG'S WEBSITE PERHAPS THEY CAN ASSIST YOU .
ASK Google

Welding Tools | Answered on Apr 13, 2019


Is free gas between the outlet of the regulator and the welder itself?

Welding Tools | Answered on Apr 08, 2019


I bought 2 more torches after finding how good the first one was. One failed after a few months, but I had no trouble getting a refund from Bunnings when they couldn't replace it - after all, they are legally obliged to replace or refund if it fails under 1 year old. Today the second one failed, so it wasn't just bad luck! I took the advice of criss994 and opened it up (you need a special screwdriver) - sure enough, the fuse had blown. Soldering a physically larger one in (M205 - 20mm long by 5mm diameter - I didn't have the 10mm x 3.6mm replacement) was fiddley but there is enough room. The original fuse is a fast-blow 1-amp rated one - so perhaps the induction coil feeding the torch causes a surge, as the unit is rated at only 1/100th of an amp. My replacement is a slow-blow 630mA fuse - it should overcome any surge problem.

Welding Tools | Answered on Mar 30, 2019


Here is a previous post about a kende that does not feed.

http://www.fixya.com/support/t26842741-kende_105f_wont_feed_wire

Welding Tools | Answered on Mar 29, 2019


Try this site for the manual you are looking for.

https://www.manualslib.com/

Welding Tools | Answered on Mar 18, 2019


You can check for your manual at this site.

https://www.manualslib.com/

Welding Tools | Answered on Mar 18, 2019


Here is a post that talks about the problem you are having.

https://forum.millerwelds.com/forum/welding-projects/2064-millermatic-200-not-working

Welding Tools | Answered on Mar 18, 2019


If you are smelling, then the engine is probably flooded. Pull the spark plug out and dry it off. Crank the engine over a couple of times with the plug out. Make sure the fuel is fresh. Reassemble and try again. Without the choke. If it does not start, use a little starting fluid.

Welding Tools | Answered on Mar 18, 2019

Not finding what you are looking for?
Welding Tools Logo

6,703 questions posted

Ask a Question

Usually answered in minutes!

Top Welding Tools Experts

David Soto
David Soto

Level 2 Expert

414 Answers

Bill Boyd

Level 3 Expert

53770 Answers

Brad Brown

Level 3 Expert

18165 Answers

Are you a Welding Tool Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...