Welding Tools - Page 6 - Recent Questions, Troubleshooting & Support


Check your torch. It sounds like the consumables are bad. Good luck.

Welding Tools | Answered on Jun 16, 2019


Sounds like a control board. Call Miller Electric to get specific instructions. Good luck.

Miller Welding... | Answered on Jun 16, 2019


It sounds like a control board. Call Miller Electric and they will be able to help you pin down the problem. Good luck.

Welding Tools | Answered on Jun 16, 2019


Call Lincoln Electric. A Lincoln service Center will help also.

Lincoln Welding... | Answered on Jun 16, 2019


It sounds like a relay is stuck closed. It could be on the control board. Call Miller welding and give them the model number and they will be able to help . Good luck

Hobart Welding... | Answered on Jun 16, 2019


A plasma stream is created when an electric arc is introduced to a gas passing through a restricted orifice under pressure ionisig the gas. The plasma stream can be controlled to carry out welding or cutting operations.

Welding Tools | Answered on Jun 09, 2019


Call a electrician unplug it turn off the breaker turn off the switch www.apparelstore38.com

Miller Welding... | Answered on Jun 03, 2019


Are you cleaning and fluxing the surfaces to be soldered?It sounds like your not getting the surface hot enough for the solder either.Use a soldering paste or flux to help.

Solder-It ... | Answered on May 28, 2019

Not finding what you are looking for?
Welding Tools Logo

6,700 questions posted

Ask a Question

Usually answered in minutes!

Top Welding Tools Experts

David Soto
David Soto

Level 2 Expert

414 Answers

Brad Brown

Level 3 Expert

18136 Answers

Bill Boyd

Level 3 Expert

53757 Answers

Are you a Welding Tool Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...