Water Heaters - Recent Questions, Troubleshooting & Support

1 Answer

Getting a low igniter current fault on my John good envirosense hot water tank. Any information will help

CALL YOUR LOCAL SELLER SORRY

Water Water... | Answered 3 days ago

1 Answer

Were is my reset bottom on my stibel eltron 8-2

at the upper part of the heating element.. press that to reset.

Water Heaters | Answered on Dec 05, 2019

1 Answer

Have a titan n-120 tankless water heater that gets very hot at sink but not hot at shower.

the common cause of that is you have higher water pressure at your sink tap..and have lower water pressure at your shower.. because your using a multi-point type water heater..it requires 2.0 ltrs/min..
you do this...try to open your shower together with your sink tap faucet.

Water Water... | Answered on Dec 05, 2019

1 Answer

How do i reset my boss therm

some heaters are there's and indicator of reset button on the unit..and some are located inside the unit can be push by using screwdriver.

Water Water... | Answered on Dec 05, 2019

1 Answer

All my electrical 240v appliances have quit working. They all have power, but won't run?

You might be having main power issues. Please contact a repairman/ service technician.

Water Water... | Answered on Dec 03, 2019

1 Answer

Help me for error code 03 in osaka gas heater

CONTACT OSAKA DEALER WE DO NOT RECOMMEND DIY FIXING THINGS THAT CAN GO BOOM IN YOUR FACE

Water Heaters | Answered on Dec 03, 2019

1 Answer

I have a grasslin towerchron qe2 timer, I have set my own heating and hot water program, however when the heating comes on the hot water automatically comes on too

see if unit is on maintain heat if so turn off

Water Water... | Answered on Dec 02, 2019

1 Answer

Richmond 6G40PV-40F Showing 4 green flashes followed by 2 green flashes Manual says lockout condition - ECO failure What should I do

Have it repaired or replaced

Water Heaters | Answered on Dec 01, 2019

1 Answer

Paloma ptg2-42pvn will not fire or fan

Hi Marty-
I found this link regarding your Paloma Tankless Water Heaters. There is a section on Troubleshooting FAQs. If you need additional technical support, there is a 1-866 number to call at the bottom of the link.

http://besttanklesswater.com/owners/homeowner+trouble.html

Hope this helps.

Water Heaters | Answered on Nov 27, 2019

1 Answer

Rheem tankless hot water heater repair in Houston

CALL A LOCAL PLUMBER

Rheem Water... | Answered on Nov 26, 2019

1 Answer

We have a new well water system...whole house with all the works....the water pressure has about 2/3's of normal...system is 2 months old...what could be the problem...Marc

did you put in a new pump or us old one and did they go deeper than old well .new faucets have pressure regulators built in for safety purpose

Water Water... | Answered on Nov 25, 2019

6 Answers

Need reset code for richmond

I am poting this here hopefully it will help someone else. I have a richmond 40 gallon power vent water heater and it was not working. It was flashing 2-3 on the LED. I used this procedure and it started up..

you can reset the control by unplugging the blower during start up, leave unplugged for at least 5 seconds, plug back in and within 30 seconds cycle temp control from hot to low 6 times.

Audiovox... | Answered on Nov 24, 2019

1 Answer

Neckar W8/10 does not startup at all , socket is fine Neckar stopped working , open up hot water tap boiler is just dead, socket is functioning fine

call your local plumbing repair service we never said we know every thing about every make made world wide .

Water Water... | Answered on Nov 23, 2019

1 Answer

I need help with my hot water heater

Well, unless you share with us what the problem is, and what make and model you have, we can't help other than to say call a plumber locally to look at it.

Water Water... | Answered on Nov 20, 2019

2 Answers

Fv sense problem code

Type of gas control valve is not known.
Brand of water heater is not known.
FV event can mean that air intake is clogged, gas control valve has gone bad, or FV system has tripped, or TCO has tripped ... or all of above.
Clean air intake, download manual from manufacturer and read troubleshoot section, call manufacturer.
Copy following links for troubleshoot resources
http://waterheatertimer.org/How-to-repair-Rheem-FVIR.html
http://waterheatertimer.org/How-to-troubleshoot-gas-water-heater.html
http://www.thetankatwaterheaterrescue.com/forums/forum3/

If you need further help, I’m available over the phone at https://www.6ya.com/expert/gene_9f0ef4df2f9897e7

Water Heaters | Answered on Nov 19, 2019

1 Answer

Richmond tankless natural gas water 199,000 btu heater will not run unless you hold the on button continuously. Ideas?

If you mean the red button you have to press when you light the boiler, then it mean that either the thermocouple needs replacing or the shroud over the flame has moved or burned through. Either way, you need a registered gas installer to fix.

Very unusual to have a heater with a remote control. Did you try changing the batteries as they may be low in power?

Advanced electronics
Every Richmond model is electronically controlled for precise temperature control, and self-diagnostic, great for maintenance and troubleshooting. The temperature of the outgoing hot water is factory set on 120 F, but by using the remote control you can easily set it in the range from 100 F to 140 F. The temperature and error codes are shown on the digital display of the remote controller.

You can Contact Richmond direct from here

https://www.richmondwaterheaters.com/contact-us/

Water Water... | Answered on Nov 14, 2019

1 Answer

We bought a Rheem Performance 40 Gal.40,000 BTU NG PowerVent TankWaterHeater 2mnths ago 7the WELL water smelled bad.rod replaced.worked for 2mnths, now it smells again.Any additional advice?

It is unlikely to be the hot water heater causing the smell, it is more likely the input (the well water) having excess sulfur, bacteria and/or organic material

Because it sits in the tank longer, the smell accumulates. If it is a bacterial source, the hot water tank may be a breeding ground for anerobic bacteria. Draining and doing a disinfect with Hydrogen Peroxide (H2O2) is the easiest and safest step

http://www.waterheaterrescue.com/Troubleshooting/stinky-water-in-hot-water-heaters.html

https://www.stevejenkins.com/blog/2015/02/fix-rotten-egg-smell-in-your-water/

Rheem Water... | Answered on Nov 13, 2019

1 Answer

I spilled water on top my kerseone heater and now when you light it it spit and spurters and it want get warm or hot. What do I do

You didn't mention the type of paraffin heater you are using, which might have been helpful.

Clearly water has contaminated the business end of the heater and oil and water do not readily mix. It should be possible to mop most of the water out of the works using absorbent paper, even if it means partially dismantling it and then relight it and persevere - the heat should evaporate the remaining water eventually.

Various companies can provide an emulsifying agent which could help with your problem. Something like Wynns Dri-fuel is designed to deal with water contamination in vehicle fuel tanks. There are other brands, usually from industrial suppliers but the Wynns product is widely available in smaller quantities.

If the heater remains stubborn after being mopped and dismantled you could brush a little Dri-fuel around the business end of the heater and add a little to the fuel - though make certain it is fully mixed...

Water Water... | Answered on Nov 13, 2019

1 Answer

I need to see a internal picture of a whirlpool electric water heater. # 1435100112354

Troubleshoot and numerous illustrations of tank and wiring appear on following links:
http://waterheatertimer.org/How-to-troubleshoot-electric-problems-with-water-heater.html

http://waterheatertimer.org/Whirlpool-Energy-Smart-electric.html
http://waterheatertimer.org/How-to-convert-energy-smart-water-heater-to-ordinary-water-heater.html

I

Whirlpool Water... | Answered on Nov 10, 2019

1 Answer

Whirlpool Gas Water heater N50T61-403 Senor failure error

Whirlpool sold the AO Smith brand flue damper, and the atmospheric models ... both models have different honeywell gas controls...
Error codes, service manuals and troubleshoot appear following link:
http://waterheatertimer.org/How-to-troubleshoot-gas-water-heater.html#honeywell

There is no specific service manual available for the flue damper series in 2019

Whirlpool Water... | Answered on Nov 10, 2019

Not finding what you are looking for?

Brands:

17,696 questions posted

Ask a Question

Usually answered in minutes!

Are you a Water Heater Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

PDF Manual

Water Heaters - Recent Questions, Troubleshooting & Support

Getting a low igniter current fault on my John good envirosense hot water tank. Any information will help

Were is my reset bottom on my stibel eltron 8-2

Have a titan n-120 tankless water heater that gets very hot at sink but not hot at shower.

How do i reset my boss therm

All my electrical 240v appliances have quit working. They all have power, but won't run?

Help me for error code 03 in osaka gas heater

I have a grasslin towerchron qe2 timer, I have set my own heating and hot water program, however when the heating comes on the hot water automatically comes on too

Richmond 6G40PV-40F Showing 4 green flashes followed by 2 green flashes Manual says lockout condition - ECO failure What should I do

Paloma ptg2-42pvn will not fire or fan

Rheem tankless hot water heater repair in Houston

We have a new well water system...whole house with all the works....the water pressure has about 2/3's of normal...system is 2 months old...what could be the problem...Marc

Need reset code for richmond

Neckar W8/10 does not startup at all , socket is fine Neckar stopped working , open up hot water tap boiler is just dead, socket is functioning fine

I need help with my hot water heater

Fv sense problem code

Richmond tankless natural gas water 199,000 btu heater will not run unless you hold the on button continuously. Ideas?

We bought a Rheem Performance 40 Gal.40,000 BTU NG PowerVent TankWaterHeater 2mnths ago 7the WELL water smelled bad.rod replaced.worked for 2mnths, now it smells again.Any additional advice?

I spilled water on top my kerseone heater and now when you light it it spit and spurters and it want get warm or hot. What do I do

I need to see a internal picture of a whirlpool electric water heater. # 1435100112354

Whirlpool Gas Water heater N50T61-403 Senor failure error

Not finding what you are looking for?

Brands:

Ask a Question

Popular Products

Rheem 40 GAL ELEC TALL Water Heater 6YR SC 82VH402

RELIANCE ELECTRIC WATER HEATER

General Electric GE SmartWater Household Water...

Rheem 50 Gallon FVR NATGAS Water Heater 6YR 22V50F1

Rheem Tankless Hot Water Heater Rtg-74pvp-2 7.4 Gpm

Top Water Heaters Experts

Brad Brown

Paul Carew

Gil Shultz

Are you a Water Heater Expert? Answer questions, earn points and help others

Manuals & User Guides

Bosch-aquastar-125b-parts-jan-2003-dia...

Bosch-aquastar-125b-pre-jan-2003-manua...

201109161755180.TWH-G1-37_Water_valve...