Irons - Page 8 - Recent Questions, Troubleshooting & Support
Hi I have a Braun CareStyle 5 iron, which has developed a fault, It omits steam as soon as it warms up and will not stop unless you switch it off any idea's ?
I have the same issue, still looking for the root cause. So far i've fixed the microswitch, the valve and the electronics main board, the issue remains, so it's not coming from that. I finally found what the issue was in my case. The problem was with the led indicator light on the iron (the one on the front, close to the buttons on the iron itself). This was shorted and was causing the electronics to latch the EV continuously when powered. I just removed the led and it's working fine. You just need to remove the white cable to the led on the screwed connector on the back of the iron, if you don't want to mess with disassembly the whole iron.
9/7/2021 8:41:05 AM •
Braun Irons
•
Answered
on Sep 07, 2021
MY ROWENTA 1550W UPRIGHT STEAMER NO LONGER
I have a Rowenta garment steamer. It will turn on but no steam comes out. Does it need to be cleaned from the build up of iron, etc. from the water? If so, how do I go about this?
8/30/2021 6:24:25 AM •
Rowenta...
•
Answered
on Aug 30, 2021
Why isn't my Iron heating up?
I do believe the thermostat is defective.All the iron have a small thermastat top control the temperature and is working like a switch.If the switch don`t work get stuck on the same position.Unfortunatly sometimes is better get a new one themn fix an old one but this is The Market and nothing i can do personally.Also make sure the thermostat knob is working properly.If you hear a click when you turn is ok.
Good Luck
7/23/2021 8:17:42 AM •
Irons
•
Answered
on Jul 23, 2021
Tefal protect concept steam button not working
hi! Long time listner, first time caller.
Iron not steaming AT ALL.
I have a tefal gv 7096
It turned on, all lights working and i can hear it heating up and when opening the calcium deposit i can see steam.
When i pressed the button - nothing. The iron it's self is hot (the plate) the lights on and but no steam.
The cord connecting the iron to the steam was also cold, so i could tell no steam was getting to the iron at all.
I wasn't sure if it was the button not working or something clogging the cord to the iron.
I did the vinegar thing. Let it sit for sometime (40 mins) and still nothing.
I did a weird thing of very carefully putting water on the plate while hot and it created steam from the plate. i think some backflowed and it started steaming, within seconds. might have happened with a bit more time anyway, but it def helped. All wokring fine now :)
7/3/2021 9:03:24 AM •
Irons
•
Answered
on Jul 03, 2021
Conair GS33 fabric steamer spews too much
Are you setting the body of the steamer on a table? If part of the hose sits lower than the steamer body steam will condense in the hose and collect in the low spot. Steam pressure will push the water out through the nozzle. If your steamer starts to sputter lift the hose so that it is completely above the level of the water reservoir and let the water drain down. Its a good idea to keep the steamer body on the floor so the hose can never get lower than it.
6/25/2021 3:12:41 AM •
Conair Irons
•
Answered
on Jun 25, 2021
Not finding what you are looking for?