Radio Communications - Recent Questions, Troubleshooting & Support
MY LG TONE HBS-730 stuck on incorrect pin
i have samsung mobile
1. TURN OFF YOUR LG TONE HBS-730 HEADSET.
2. PRESS AND HOLD THE VOLUME UP BUTTON ON THE HEADSET WHILE TURNING IT BACK ON.
3. RELEASE THE VOLUME UP BUTTON WHEN YOU HEAR A TONE.
4. YOUR LG TONE HBS-730 HEADSET WILL BE RESET, AND YOU CAN PAIR IT WITH YOUR SAMSUNG MOBILE PHONE AGAIN.
Icom IC706mk2g Transceiver does not transmit in SSB (Single Side Band) (USB & LSB)
First, make sure that the microphone is properly connected to the transceiver. Check all the connections and ensure that there are no loose cables.
Next, check the settings on the transceiver to make sure that it is set to SSB mode. Sometimes, the mode settings can get changed accidentally, so it's important to double-check.
If the issue still persists, try resetting the transceiver to its factory settings. This can sometimes resolve any software glitches that may be causing the problem.
If none of these steps work, it's possible that there may be a hardware issue with the transceiver. In that case, it's best to contact a professional technician for further assistance.
3/28/2024 10:24:30 AM •
Radio...
•
Answered
21 hours ago
I have a Roadking the original in chrome how do I wire it for my galaxy 66? It has 5 wires plus the shield wire need to go to a 4 pole plug.
If your radio is a Galaxy DX66V then I believe that the Turner Road King should be wired to the 4 pin plug with:
Pin > Usage > Connection
1 > Ground > Shield & Red
2 > Mic Audio > White
3 > Transmit > Blue
4 > Receive > Black
If you want to confirm the mic wire colors use an ohm meter to test the following:
With the mic button not pressed:
Shield and Yellow are connected together
Red and Black are connected together
Blue is not connected to anything
White is not connected to anything
With the mic button pressed:
Shield and White are connected through the microphone transformer
Red and Blue are connected together
Yellow is not connected to anything
Black is not connected to anything
Hope this helps.
New 44 hp wont recieve
Hi,According to the heading under Problem with:Galaxy DX-44HP Mobile Amateur Radio.If this is correct, Are you a licensed Amateur Radio Operator?If not, Then You will not be lawfully able to operate any Amateur radio until you are licensed, sorry, but thems the rules, and I'm not going to encourage or help anyone to be able to transmit these radios, without the credentials being made available first.Cheers,Peter
I have a cb radio in the car and one at home if i
radios are very picky beasts, the first thing you should do to get more range out of them is have them tuned by a cb dealer, from factory they rarely get out very far. also for the one that goes in your car antenna placement is very critical since your car body affects how the signal travels. even the length of antenna cable has a effect. when you have them "tuned" many times they will clip a resistor or "limiter" inside the unit. if you look up cb modding, youll find pages with 100s of makes of cb's and learn what modding them means. also look into high gain antenna for your units, if you want really long range buy a linear antenna "illegal in a lot of places" but you will be heard! people have used high gain antenna, and "skip" to talk to people in other states and countrys. skip is when the radio signal "skips" across the uppter atmosphere and uses it like a really big antenna. a lot of truck stops will have a good selection of antennas because cb is still very popular amongst truck drivers. i hope this helps you out and leads you in the right direction. cb is almost a lost art now and its nice to see people that are interested in it. take care and good luck!!
Serial Number for KPG-790
All questions need FULL 'make model (what it is) first 3 words please.
Something to do with this? The serial number should on the label on the rear by the mains cable. This is a statutory requirement unless someone removed it to hide its identity.
https://www.google.com/search?q=KPG-790
..
2/15/2024 3:06:45 AM •
Radio...
•
Answered
on Feb 15, 2024
I need help to dismantle a motorola radius sp10 2 way radio
Remove the battery, slip a small screw driver into the slot at the bottom of the radio between the outer housing and the battery tray, gently pry up. If your radio has a pair of battery contacts on the exterior they will come up with the tray. Be gentle, and do not disturb the Mylar ribbon that runs down the back of the tray. Once the tray is removed, using a frame removal tool (shaped like a squared letter U) you slip the tool in the channels on either side of the radio where you removed the battery tray. Then slide the tool upward until it meets the two plastic ears. The tool will slip under the ears and using your tool you can push the component board out the top of the housing. If your radio has an 8-dip-switch private line board, you may want to watch you do not damage or dislodge it in the process.
Not finding what you are looking for?