Bosch Washing Machines - Page 4 - Recent Questions, Troubleshooting & Support
Bosch WFD 2473 - wont spin. I've taken out the
Even if the pump is not working, then so long as there is no water in the washer, it should spin
If it does not, then I would suspect the motor brushes are worn out.
You need to remove the motor to check the brushes, if they are less than 2 or 3 mm long then they need replacing.
I do not think the washer you found is off the pump,more likely out of someones pocket.
Hope this helps with your problem.
E47 error code Bosch washing machine
Hi Adrian.
this is all i can find,
Bosch Washing Machine E47 Error - Heat Sink on Motor PCB Fault
Description:
Heat sink on the motor control module is broken.
Action To Take:
- Replace motor control module.
- or go to this link it will give you all the codes.
- https://appliancefault.com.au/faults/washing-machine-faults/bosch-washing-machine-fault-codes/
I have a bosch nexxt 500 series washing machine . It is filling and draining st same time. What is causing this
It's likely that you have a siphon occuring. Check the position of the drain hose. The bottom of the end of the hose must be above the maximum water level of the washer. In some cases, you may just need to pull the drain hose up and secure it so that it isn't pushed too far down. For other cases, you might need to lengthen the stand pipe by adding a coupler and another length of pipe. (If you have the drain hose going into a laundry sink, you might need to raise the sink if there is no easy way to get the hose secured in a higher position.)
I hope this helps.
Cindy Wells
Not finding what you are looking for?