Bosch Irons - Recent Questions, Troubleshooting & Support

Question moved from Sewing Machines category. Duplicate question Deleted, refresh page to see your question. Too old for the internet, it is from the 1950s (like me) https://www.google.com/search?q=Bishman+tire+880-61+user+manual ..

Thanks for that Tim, very useful indeed. Siri did well, but there were two typos which I fixed 'price', to 'prise' and 'stripey' to 'stripy'. These videos may have been helpful for Sensixx and may have been the ones you watched. Thanks again, much appreciated. .. https://www.youtube.com/watch?v=9kTFaHDxkG4

If the temperature control dial of your Bosch Sensixx x DA30 iron has become stiff, you can try the following steps to make it easier to turn:

1. Unplug the iron and let it cool down completely.
2. Using a soft cloth or sponge, clean the dial and the surrounding area to remove any dust or debris.
3. Apply a small amount of WD-40 or silicone spray lubricant to the temperature control dial.
4. Slowly turn the dial back and forth a few times to distribute the lubricant and loosen up any dirt or debris that may have been causing the stiffness.
5. Wipe away any excess lubricant with a clean, dry cloth.
6. Plug in the iron and turn it on to make sure the temperature control dial is turning smoothly.

If the stiffness persists or the temperature control dial is still not turning smoothly, you may need to take your iron to a professional for repair or replacement of the dial.

replace cord

It would be more cheaper and easier just to buy a new clothing iron than to try and fix the steam release button on your iron.

dead short in the iron or lead brand new , take it back for a new item under warranty

Soak the base in vinegar and water for two hours, shake it and see the junk come out. Repeat with fresh vinegar and water. Leave the iron in the airing cupboard overnight to dry out internal condensation. Next day half fill iron with vinegar and water leave two hours, empty. Plug in it will likely heat up again so put water in the iron and heat it up then unplug use the calc clean and shake it over the sink

Do you drain the vinegar before turning on the iron and steaming through?

Yousaf/Tony, Either the switch is defective or the heat element has gone bad, probably not cost effective to repair.

GE 11-2120 CD Stuck. Unplug from power supply, detach speaker wires, detach antennae wires. eject any cassette tapes, remove any CD's you can reach. Then, hold the unit upside down, front panel facing you. agitate to let the CD fall down. With care, roll unit so that front faces downward briefly, then back to the upside down position, facing you. With care, roll it clockwise so that the top is upward, all the while keeping the front panel facing you. Now agitate lightly again, to seat the loose CD in one of the five openings in the revolving tray. set the unit on a table, plug it in to an outlet, open the CD mechanism, hit "skip" on the remote control until CD is visible. remove it.

i use a wet green scarer when iron on warm