How to set the time on a B7500M AEG oven
To set the time on an AEG B7500M oven, follow these steps:
- Press the "Clock" button on the control panel. The display will show the current time.
- Press the "Hour" button to set the hour. Use the "Plus" and "Minus" buttons to adjust the hour.
- Press the "Minute" button to set the minute. Use the "Plus" and "Minus" buttons to adjust the minute.
- Press the "Clock" button again to confirm the time and exit the time-setting mode.
Note: If the oven is in the process of cooking or baking, you will not be able to set the time until the cooking or baking process is complete.
3/6/2024 2:40:18 PM •
AEG Ovens
•
Answered
on Mar 06, 2024
Washing machine aeg 64840
Remove the line to the water level sensor, release the vacuum and it might solve. Also check inlet and drain blocks.
If the
water flows though the inlet then the flow pressure should be good, if not the
inlet valve is bad or there is dirt in the filter. Also check the flow at the
inlet of the water line. Once the water comes into the system the WATER LEVEL
SENSOR - normally a pressure switch- must activate at the preset/chosen level
to give the signal to the program controller to switch on the motor. What is
most important for the motor to start functioning is that the door switch must
be ON when the door is shut or this will be an error for starting the motor for
rinse and wash.
AEG oven tripping rcd at random points?
An RCD tripping points to an earth leak because that is what they are designed to do.
Check the wiring and pay special attention to the insulation.
10/8/2023 7:36:45 AM •
AEG Ovens
•
Answered
on Oct 08, 2023
AEG FAVORIT 35085 Vi dishwasher Beeps 5 times and stops
If your AEG FAVORIT 35085 Vi dishwasher beeps five times and stops halfway through a wash cycle, there could be a few potential causes for this issue. One possibility is that there is a problem with the water supply, such as a clogged or partially blocked inlet valve. Another potential issue could be related to the drainage system, such as a clogged filter or a malfunctioning drain pump. It's also worth checking if the dishwasher's spray arms are spinning freely and not obstructed by any debris. If the problem persists, it is recommended to consult the dishwasher's manual or contact AEG's customer support for further assistance. They can provide specific troubleshooting steps and guidance based on your dishwasher's model and any error codes that may be displayed.
AEG LAVATHERM 303
The date of manufacture is often identified by the serial number of your unit. Each manufacturer uses their own "code" to identify the month and year. You can often find websites that will tell you how to decipher your specific serial number.
5/16/2023 8:01:24 AM •
AEG Dryers
•
Answered
on May 16, 2023
Not finding what you are looking for?