...fuser roller cleaner or worn rollers. Check exit sensor, is it out of place, is the actuator worn out, is the paper curling and coming off of the paper too early, Try these, hope it is of some help. ...
Question about AcuLaser C1900 Printer
...worn fuser unit appears even after changing to new fuser epson aculaser c1900 error code eq023 & worn fuser unit msg appears even after changing new fuser transfer belt cleaner error replace the ...
WORN FUSER? WHAT DOES THIS MEAN PLEASE WORN FUSER? WHAT DOES THIS MEAN PLEASE that means there is a fuser unit back side of u r printer this is the main unit where printing happens actually. I think ...
...fuser is worn out. It can be replaced as an assembly, but sadly it is actually less expensive to replace the printer these days. The wrinkling is due to a worn pressure roller, and the darkness is ...
...worn out fuser. pull the fuser out and inspect the rolllers if the orange roller (the pressure roller) has bad wrinkling or if the shinny sleave of the roller has slid off to one side replace hte ...
...If it is not the cartridge check the fuser. Open the back access cover shine a light in and look for wear marks on the grey fuser film. If it is worn the fuser film is worn it should be
...fixing fuser film is worn out or broken remove the fixing unit ang check the fuser film if its worn out broken replace a new one . Hope this helps. Please rate my response. Thanks. Have a good ...
Question about imageCLASS D320 Digital Copier
...fuser may also be worn like the rollers This should be done by a trained certified engineer WHEN YOU TURN OF MACHINE MAKE SURE TO OPEN DOORS AND WAIT A FEW HOURS SO THE FUSER AREA CAN COOL DOWN ...
...worn and 2. the fuser drive gearing on the left hand side of printer ( as you look at it from the rear ) may also be worn. I have replaced bearings before but they dont seem to last for long. A new ...
Question about LaserClass LC 8500 Plain Paper Fax
...fuser assy is worn and not fusing the toner onto the paper correctly. This is easy to check. Does the print rub off the paper with your finger? If so then a new fuser is required. Also its possible a ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions
