Questions & Answers for: wire 12v switch

...power and the 12V illumination wire is zero - they are both now at the same voltage and no current will flow. Once you find (or install) the correct ground wire and you should be

...12v wire each wire until radio works.if when checking the starter tries to turn that is the starter wire.The 4th wire to test is ignition wire(power to coil)plug test light/probe into positive coil ...

wire to switch the 12v hot with the ignition. This will prevent dead batteries if I leave the heated grips on or if a passer by feels the need to flip switches on my bike; it's happed before! You will

...switched by ignition The 12V constant on the yellow wire allows for settings to be stored when the ignition is off. The 12V switched by the ignition on the red wire is what powers the unit up for

...12V at YEL wire (from ignition switch) at the switch when ignition moved to START position. If 12V present at YEL, but absent at PPL (also in START position), replace the Park/Neutral switch. If no ...

...If the switched 12v is wired the wrong way round or linked to a permanent 12v then the radio won't switch off when you remove the key. Could be the ignition switch itself stuck on all the time

...and the relay. If the headlight assembly is receiving +12v at the connector, check the bulb. If the bulb tests good with an ohmmeter, check for a broken ground wire. That is simply all there

...12v switched which one do I wire to my 12v power supply 12V switched means that the connection is controlled by the Key position. If the vehicle is off and key out, then the radio cannot be turned

...EVEN AFTER TURNING IT OFF AND REMOVING THE KEY It sounds like you have a constant 12V power supply wired to the radio instead of a switched 12V. If you've recently installed a new radio, check your ...

...And the power antenna is used to raise and lower the antenna which can also be wired into the plug C. So essentially you can have more than wire run into your switched/+12v wiring to the fuse