Questions & Answers for: wiper works high speed

Question about 1997 Grand Voyager

1 Answer

...low speed stopped working.A few weeks later high speed quit working too.I just replaced the wiper motor last year. check to see if you have life at the wiper motor plug.if not.you have a dodgy

Ad

Question about 1997 Grand Marquis

2 Answers

...wiper motor ($100.00 part). Since I have found it on Amazon for $58 including shipping. It works fine now. Only bad part was all the "stuff" that has to come out (like dead leaves!) to get to the ...

Ad

...speed. have changed sw, didnt help wipers quit working low speed & delay, wont park. work fine high speed. have changed sw, didnt help When they won't park it's 99% need new wiper ...

Question about 1994 Ranger Supercab

1 Answer

...Wiper Only Works On High My windshield wipers only works on high speed. I have changed the switch still the same. Is there anything else I can do to fix this problem? There is a wiper speed control ...

...high The problem would be in the stalk controller. The wiper Relay is what provides power to the motor for all settings, the delayed wipers, low speed, and high speed. There are not 3 relays, but 1 ...

high speed, i would say, most likely will have to replace it. Having windshield wiper/washer problems? Here are some more common problems. Motor: The wiper motor is commonly replaced and was often not

...Wiper high PCB relay ?€¢ Windshield wiper motor ?€¢ Windshield washer fluid pump ?€¢ Windshield washer fluid level switch ?€¢ WPR fuse 25 A ?€¢ WSW fuse 10 A Low Speed Operation When the wiper switch ...

works also. Search Results My windshield wipers only work on high speed...? ' Yahoo Answers https://answers.yahoo.com/question/index?qid... Nov 11, 2006 - My windshield wipers only work on high speed.

...HIGH speed wiper motor operation, the wiper switch signal circuit is at the LOW speed signal voltage, and the body control module (BCM) supplies redundant voltage to the wiper relay via the wiper ...

Wiper Relay? I bought a new motor and pulse board, installed an its still doing the same thing. Then works just like they are intended. But they will not shut off. I must turn engine off an wait a few

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...