whining noise is comming from the back of the truck. Noise isn't all the time, Just when Driving at a constant speed or accelerating. When Decelerating the noise suddenly stops. Just replaced U-joints
...noise A whining/humming noise is heard when foot is removed fromt the gas. The sound is more audible at 65 mph decelerating to about 40 mph. The sound is audible at lower velocity around 20-40 mph, ...
whining noise on deceleration, started at higher speeds but now whines even at lower speeds. pulls to the left whines more when 4wd is engaged, rythmic lurching at lower speeds that stops when 4wd is ...
rearend prob.[noise] Here are the common causes or rear end noises Constant high pitched whine at all speeds: Pinion Bearings or Ring gear carrier bearings Whine at steady speeds or whines on ...
...and rub the case. The ridges on top of the belt will make a terrible whining noise. So, check the belt to make sure it's properly tensioned. Test the belt with the rider on the bike. Good Luck ...
whining noise front drivers side I have a loud whining noise in the front drivers side. Started today as I was driving and got progressively louder the longer I drove. It is louder with acceleration ...
Question about 2006 Corvette
I have a 2006 Corvette that produces a whining noise from the rear end when decelerating from 68-60? I have 42000 miles on my Corvette and this noise just started. bad axle or pinion bearing
Question about 2006 Colorado
whining noise from the rear end when decelerating from 68-60? I have 42000 miles on my Corvette and this noise just started. The ring and pinion have been replaced and the noise has not gone away. Did
Question about 2006 Colorado
...WHINING NOISE IN MY 07 KAWASAKI VN1600B MEAN STREAK MOTORCYCLE THIS WHINING NOISE ONLY OCCURS DURING DECELERATION, NEVER DURING ACCELERATION OR WHEN THE CLUTCH HANDLE IS IN probably clutch related, ...
Question about 2006 Colorado
...developed a whine when decelerating. Probably best described as a faint jet engine winding down. The noise fades when the engine is under load. Whats the problem? Possible gear noise or bearing
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions