...water' (to level allowing door to open)...filter is cleared..drain and hose are clear because all water can be removed by dropping below drum level.. Check drum something may be caught on heater not ...
Question about Aquarius WMA52 Front Load Washer
to correct level. to get the water out in any case put the drain hose end lower than the water level into a basin to syphon it out. lifting the hose above water level will stop it till you empty basin
Question about Aquarius WD640 Front Load Washer/Dryer
...water in the dispenser drawer after every wash any ideas please? Check to see if the unit is level, as the unit should be level front to back and side to side. If installed in a home, you'll need to ...
...water level switch. The inlet valve can be tested reading continuity on valve solenoid contacts, check also the water level switch actuated by a floating sensor. If they are ok then the problem is ...
Weak Agitate. Water drains ok, starts to spin then stops, start again then stop, once water level has gone down, spins fine change water level switch
...Water-level switch Water-inlet valve A defect in the water-inlet valve may mean that it's no longer able to shut off completely when the electricity has been turned off to it. If this occurs, the ...
Question about Aquarius WF220 Front Load Washer
water level sensor, included to check the small hose from the drum to the water level sensor. there must be pressure from the water to suppress these sensors, the operation of the washing machine are:
washing machine keeps filling with water I would say your water level sensor is broke. It reads the water level and cuts it off when it is appropriate.
Question about Aquarius WMA56 Front Load Washer
...water level should be about 1/2 to 3/4 inch deep at front of dishwasher. If low water level--inlet water valve (plastic part house supply hooks to) either needs cleaned or replaced. Most cases just ...
water make sure the machine is level by adjusting the feet or rollers. make sure the icemaker is level in the cabinet and tightened firmly. verify the water delivery tube is in the correct position to
Usually answered in minutes!
886 Questions
666 Questions
541 Questions
485 Questions
500 Questions