Questions & Answers for: washing machine water path control

Question about Neptune MAH5500B Front Load Washer

2 Answers

...Machine works great, but the wife informs me it no longer dispenses Fabric Softener. Manually checked soleniod valve, jumped it with 110 and all solenoids work fine. Tech says only thing left is ...

Ad

Question about GWL11 Top Load Washer

1 Answer

...washing machine Leaks on floor. during Spin or Empty cycles. What are the most probable leak paths or Parts Hi and welcome to FixYa! Some things to check- Start with the water pump underneath the ...

Ad

Question about GWL11 Top Load Washer

2 Answers

...washing machine miele gala grande w 3000.and i have a tech fa ult f63.what is this? Same issue here with the Water Path Control Unit of Miele W 4840. No teeth broken on any gear, and the motor was ...

Question about GWL11 Top Load Washer

2 Answers

...washing machine miele w 3000 tech fault f63.what i can do? Mine is W3844. Miele's technician said the Wather Path Control Unit (part # 6271992) need to be changed. Total Cost: (HKD) 450 for todays ...

Question about GWL11 Top Load Washer

2 Answers

...water. It than stops and an error code F11 comes up. No where in my Kenmore manual does it give an explanation for error code F11. Please Help Hi Thanks for using FixYa. F11 is a communication error ...

Question about Touchtronic W1213 Front Load Washer

1 Answer

...washing machine thanks in advance for your precious help regards Hi vianney_dupa, Your water path control unit is not registered by the PC Board. This is the Pressure switch / Water Level Switch. ...

Question about W 4800 Front Load Washer

1 Answer

...washing machine just had a fehler f63 error. What does this mean and is it fixable? heres your problem.. 3.33 Fault code F63, water path control unit In normal operation mode the display shows ...

Question about W 4800 Front Load Washer

1 Answer

...water path fault - This is the control unit that directs the water flow to the proper path (pre-wash, detergent, fabric softener ect..... ) Sometimes and audible clicking can be heard when this unit ...

Question about W 4800 Front Load Washer

2 Answers

...Water path control system faulty. The power-programme module (ELP) cannot register a valid position of the water path control unit within approx. 80 s of it being switched on. You have to replace ...

...washing machine FA DTC. Aquastop is active. What it means? What is the solution? This message means that a water sensor in the base of the washer has been tripped. This usually means that there is a ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Washing Machines Experts

Brad Brown

Level 3 Expert

19187 Answers

Cindy Wells

Level 3 Expert

6688 Answers

john h

Level 3 Expert

29494 Answers

Are you a Washing Machines Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...