Questions & Answers for: washer sediment left drum

...Washer Does Not Dispense Softener I noticed that the softener is left in the dispenser after the wash is complete. Taking a soft bristle brush and cleaning the holes directly above the softener ...

...washer, just inside the door, there was a very slight and nearly unnoticeable stream of water gliding down the rubber seal. My guess is that there is some sort of water control valve that has failed. ...

washer. Feels like the drain line is filled with sediment however I do not know how to access the base of the line so that I can disconnect and clean out. No water is coming throught this drain line..

...washer where the fill hoses attach. There is a separate solenoid for the HOT and COLD water. These two valves are controlled electronically, but the small diaphragm that controls the water turning on ...

...washer where the fill hoses attach. There is a separate solenoid for the hot and cold water. These two valves are controlled electronically, but the small diaphragm that controls the water turning on ...

...sediment and replace them in the hot and cold water washer valves on the appliance. 6 Unscrew the hot water supply hose from the valve using adjustable pliers. Turn the hose connector clockwise to ...

washer drum fills with smoke at end of last rinse cycle and smells of burning rubber Cycles seem to run fine until the final rinse, then lots of shaking like load is off balance. Drum fills with smoke