...turn. or mover up and down that much. the drive shaft to the rear diff would have more stress. I would have a garage check it out ASAP. cause you would need someone under there to check. i dont ...
...drive shaft not turning anymore tried to turn by hand ,wont turn . transmission works fine truck has 140000 mi no leaks Sounds like a broken CV axle in the right front. I have a 99 k2500 same thing ...
Question about 1995 4Runner
...drive shaft or U joints? I put the car in a lift gear in drive and ck the sound, the sound come from the drive shaft, i was unable to identified if is the proper drive shaft or U joint is it a ...
...shaft from ****** .thru clutch pack to gear, output to rear drive . gear linked to front gear by chain. chain will strech over time and slap inside case if bad enuff . but will sound like clunk if ...
...the drivers side. Cant figure out what it is! Drive shaft?? Have not replaced that yet. Please advise. Thank you. check u-jounts and motor mounts and usually vib during braking is either rotors or ...
...drive shaft..especially where the drive shaft meets the transmission. have you had your transmission fluid and filter changed? As far as noise goes, bad u-joints usually click or squeek. On the other ...
...noise at front end at any speed grinding clunking scraping Sounds like your front drive shaft between the tansfer case and the front differential. Or it is a Haft shaft going out to the front
Question about 2009 H3
...but if not engaged in 4 wheel it dosn't turn . If we are talking 4 wheel drive witch it must be to have a transffer case in the first place look at the main drive shaft thats what is wrong U ...
Question about 2004 F-250 Super Duty
...clunking sound coming from the transfer case on a 2004 Ford F-250 when the truck is in park and you rock it back and forth it makes a clunking sound in the transfer case Slip yoke and output shafts. ...
Question about 2004 F-250 Super Duty
...and turning left. I hear a clunk noise on the left side. A space between each clunk. A soft clunk. Thank you Sounds like a universal joint failure on the drive shaft... Axle joints are wearing
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions