...temp. control switches. You may need to remove the ducting and clean up the rods and cables that flip the door from the hot to the cold side lubricating them, then move the door by hand while moving ...
...temp knob was broken and the cable to open and close the heat vent ..was no longer connected...to check turn knob from red to blue a few times and listen for vent door movement...also u can look on ...
...temp knob to transfer form cool i can not get the temp knob to transfer from cool to heat on an '02 nissan altima, how can i fix this, thanks most likely you'll have to replace the plastic tab on the ...
...temp setting on the dial. what could be wrong? sounds like the cable connecting the knob to the blend door came off or broke or worst case blend door broke -this is bad because it is a big box behind ...
...TO BE A BLEND DOOR MOTOR PROBLEM YOU NEED TO FIND THE BLEND DOOR MOTOR UNDER DASH MOVE TEMP KNOB BACK AND FORTH. SEE IF BLEND DOOR IS MOVING IF NOT MAKE SURE YOU HAVE VOLTAGE. IF SO REPLACE BLEND ...
...temp contol knob is only moved one click This can be caused by a bad controls or bad blend door motor, the door motor and controller will need to be tested to see which is causing the problem, ...
...temp knob wasnt broken,flushed and bled system.Nothing worked so checked hoses to heater core and found inlet hose was hot,outlet hose was not.So investigated this problem and came to conclusion ...
...goes full hot My heater goes full hot as soon as you move the temp knob from full cold. There is no middle setting. It's either full hot or full cold. Take back To Nissan dealer,warranty will
Question about 2006 Frontier
...temp control knob,can hear the servo moving the temp door in increments-will not deliver in less than Max vehicle has AC,and is equipped with the DOHC 4.0 litre V6, automatic trans, cruise,etc. I ...
Usually answered in minutes!
1,587 Questions
1,450 Questions
1,309 Questions
1,122 Questions
1,306 Questions