...switch that cuts out the power and blade if you get off the seat. Any thoughts? When you pull switch to turn on blades do you here a click sound ? If so clutch is most likely ok,did you check your ...
toro 216 triple mower . the electric clutch will not switch off leaving the blades in drive all the time . can the clutch be striped down and repaired the switch where the blades are engaged try to ...
Safety switch located where is the safety switch located? Will this keep the blades from engaging? Micro switches will just stop the engine if the blades are engaged and the operator leaves the seat, ...
Question about Toro Garden
switch is in the off position. The blade brakes not gripping the pulleys fully to stop blades so anything brushing against the blade will start them spinning Or the clutch medium is damaged and is not
...grass blades disengaged when backing up then cutting grass the blades quit then I cycled the switch I was cutting grass and blades quit then cycled the switch and blades started then later ...
Question about Garden
...blade switch was replaced because the blades would not turn on, now the shut down problem has came up the original problem was that the blades could not be turned on. I replaced the blade switch and ...
Question about TimeCutter SS5000 zero turn mower
...blade control switch Off. Move Either Motion Control Lever To The center, unlocked position. Try starting the engine; the engine should not crank. Repeat With The Other Motion control lever. 3. While ...
Question about TimeCutter SS5000 zero turn mower
...blade switch is pulled If you are sitting on the tractor seat and the engine stalls when engaging the PTO mover blades I would check the switch under the seat. This seat has a saftey switch to assure ...
...John deer 130 not starting. New battery. Was running, then blades would not engage. I replaced the switch that controls blades. Then mower will not even turn over to start. What do I check now?
Question about TimeCutter SS5000 zero turn mower
one that is the same as the first check is the common input blade to the switch. Now that you know which blade is the input, you can check continuity to the other four blades by moving the switch knob
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions