starter stuck on Hi, I have a 1996 triumph t-bird. today I tried to start the bike and the starter got stuck on. (I dont know if it was the starter motor or a switch prob) Even when I turned off the ...
...starter was stuck and not engaging, the bendix drive inside the starter has failed...In that case it's best to change the starter as even though it's replaceable, generally by the time it needs ...
starter stuck on If your starter will not stop turning over then your starter solenoid contact bar is stuck in the closed position. It should only close when you hit the starter button. With the ...
starter stuck in start mode my 2000 ford expeditions starter got stuck on the start mode it made an awful grinding noise, they said it was the because the battery was too small, but then all the fuses
...starter is stuck, apply rust penetrant around the area where starter mates with trans. Try to remove by hand after soaking for two hours. If still stuck, get a two by four and lightly tap the starter ...
...the relay , pull relay to see if it stops this starter stuck, if yes, its bad or the key switch is stuck. if it still cranks with relay pulled, then solenoid tiny wire the starter is TOAST>
Question about 1993 Corolla
...starter gets stuck and keeps trying to start even when releasing key have to turn off and remove key to stop starter there are a few things that will cause this problem 1 is a stuck solenoid, 2 ...
Question about 2001 Expedition
...correct ones have been removed, the starter should at least move a little.If not. tap starter with a hammer to see if it will loosen up. The starter drive may be shot and stuck against the ring
Question about 2001 Expedition
starter got stuck engaged , now nothing Disconnect the battery... remove the starter and have it checked.. this will tell you why the starter got stuck...(if there is nothing wrong with the starter...
Question about 2001 Expedition
...starter on a john deer d110 riding mower and it engages the flywheel then it gets stuck if it gets stuck on the flywheel it may not be the right tooth count. or it may need a shim put between the ...
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions