Questions & Answers for: Isuzu starter fuse

...no burn burned up ignition swithes or fuses. see fuse 12 below. 10amps that fuse can not run a solenoid direct, the relay must be working. the starter solenoid uses a 60amp fuse. blk wire

...Starter fuse(glass)-behind the front driver side wheel.The starter relay was also replaced.No lights to dash,except if I run a jumper from wire side of 50A starter fuse to pin1(W/B wire)of ign ...

starter motor.Thanks Check ALL of your fuses and circuit breakers in your fuse box under the hood. I REALLY need more information from you to go further. Please let me know what you find and I will be

...fuse is OK, get a new starter relay. If the fuse burned without the relay, there is a short between the ignition switch and the starter relay. If you have a manual transmission, you can further ...

...start fine again IT IS A SOLONOID ISSUE,NOT A RESET FUSE.GET A NEW ONE,YOU WILL BE OK.THERE IS A COPER DISK IN IT.ROTATES EVERYTIME YOU START.NOT GOOD CONNETION.CHANG THE SOLONOID,NOT THE THE

...starter fuse goes hot with key in start position, so you need a helper to turn the key while you check for voltage at the fuse. At the starter motor, two voltage circuits, one comes from the battery, ...

...you are using the proper fuse. If so, disconnect the starter solenoid and then try to start the vehicle. If the fuse does not blow, the starter solenoid (entire starter, actually) should be

fuse named"starter" no less. we have posted no cranks here like 100 times now and is same on most cars (with key starts) that have automatic transmission, do you..? My guess is the car will not jumper

fuse (antitheft) this module kills the starter relay dead. (can be bypasses ask) finding a 2nd key or fixing antitheft on any Isuzu (they bugged out in usa, ) can be hard finding support for isuzu, in

...starter fuse/relay. Check the attached links,instruction and guides, Good luck "I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you ...